60.Remove the
(5) with the 1/4” x 5/8” Screws (95).
Repeat steps 59 and 60 to attach the other set of shrouds (not shown) over the other weight stack.
61.Attach the Press Plate (55) to the Press Front Leg (20) by securing it with the Lock Pin (22). Note: The lip on the Press Plate must be on the upper edge.
See the inset drawing. Be sure that the Lock Pin (22) is positioned as shown.
60 |
34 |
109 |
5 |
95 |
61 |
22 |
55 |
20 |
55 |
22 |
62.Make sure that all parts are properly tightened. The use of the remaining parts will be explained in Adjustment, beginning on page 24 of this manual.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See Trouble- Shooting and Maintenance on page 25.
21
