4.Hold the Handrail (5) near the Left and Right Uprights (35, 36). Connect the Handrail Wire (2) to the Reed Switch Wire (6). Insert the Wires down into the Left Upright.
Attach the Handrail (5) to the Uprights (35, 36) with four M8 x 15mm Bolts (33) and four M8 Washers (34). Be careful not to pinch the Wires (2, 6).
See step 1. Tighten the four M8 Nylon Nuts (13). Attach the Resistance Control (44) to the Right Upright
(36)with the M5 x 12mm Bolt (46) and the M5 Washer
5.The Console (1) requires two “AAA” batteries. Alkaline batteries are recommended. Press the indicated tab on the Battery Cover (27), and remove the Battery Cover.
Insert two batteries into the two battery clips; make sure that the negative
6.See drawing 6a. Hold the Console (1) near the Handrail
(5). Connect the wire on the Console to the Handrail Wire (2). Attach the Console to the Handrail with two M4 x 12mm Screws (3). Make sure that the wires are not pinched.
See drawing 6b. Press the Battery Cover (27) back onto the Console (1).
Make sure that the walking belt is properly tightened (see SYMPTOM 3 on page 8).
7.Remove the paper backing from the Adhesive Clip (30). Press the Adhesive Clip onto the Left Frame Endcap (24) in the indicated location. Press the Hex Key (20) into the Adhesive Clip.
4 |
|
33 34 | 5 |
2 |
|
6 |
|
35 | 34 |
| 33 |
46 |
|
47 |
|
36 | 44 |
5 |
|
Batteries
1
|
|
| Tab |
27 |
|
|
|
6a | 1 | 6b | 1 |
|
| ||
|
|
| |
2 |
|
|
|
3 | 5 | 27 |
|
|
| ||
7 |
|
|
|
| 20 |
|
|
|
| 30 | 24 |
8.Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill.
5