Weslo 7.9 Assembly, Make sure that the power cord is unplugged, Do not fully fold the Frame yet

ASSEMBLY

To hire an authorized service technicianto assemble the treadmill, call 1-800-445-2480. Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the walking belt is coated with high-performance lubricant. During shipping, lubricant may be transferred to the top of the walking belt or the packaging. This is normal. If there is lubricant on top of the walking belt, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys and your own Phillips screwdriver				,
adjustable wrench	, rubber mallet	, and scissors	.

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it is preattached to one of the parts to be assembled. Extra hardware may be included. To avoid damaging plastic parts, do not use power tools for assembly.

M8 Star	M10 Star		#8 x 1/2" Screw	M4.2 x 25mm Tek
			(22)–1	Screw (2)–4
Washer (10)–4	Washer (8)–8	Base Foot Spacer	M4.2 x 19mm
		(104)–2		M8 x 25mm Bolt (6)–4
			Screw (1)–6
1/4" Washer			1/4" x 3 1/2" Bolt (4)–4
(9)–4
Bolt Spacer (79)–4			M10 x 96mm Bolt (5)–4

1. Make sure that the power cord is unplugged.	1			B
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the			77	A
Frame (48) so that the treadmill is more stable;
do not fully fold the Frame yet.				Hole
Remove and discard the two indicated bolts (A)	85			8	2
and the shipping bracket (B).
Cut the shipping tie securing the Upright Wire	48
(77) to the Base (85). Locate a tie in the indi-
cated hole in the Base, and use the tie to pull the
Upright Wire out of the hole.	104	81
Attach a Base Foot (81) to the Base (85) in the lo-			2
cation shown with a Base Foot Spacer (104) and
an M4.2 x 25mm Tek Screw (2). Then, attach an-
other Base Foot (81) with only a Tek Screw (2).	6