Weslo 7.9 warranty HOW to Fold and Move the Treadmill, HOW to Fold the Treadmill for Storage

Page 17

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE

1

Before folding the treadmill, adjust the incline to the

 

lowest position. If you do not do this, you may damage the

 

treadmill when you fold it. Remove the key and unplug the

 

power cord. CAUTION: You must be able to safely lift 45

Frame

lbs. (20 kg) to raise, lower, or move the treadmill.

1. Hold the metal frame firmly in the location shown by

 

the arrow at the right. CAUTION: To decrease the pos-

 

sibility of injury, do not lift the frame by the plastic

 

foot rails. Make sure to bend your legs and keep your

 

back straight as you raise the frame. Raise the frame

 

about halfway to the vertical position.

 

2. Move your right hand to the position shown and hold the

2

treadmill firmly. Using your left hand, pull the latch knob

to the left and hold it. Raise the frame until the pin is

 

aligned with the gap between the frame and platform,

 

and then slowly release the latch knob. Make sure that

 

the latch pin is fully inserted into the gap.

Frame

To protect the floor or carpet from damage, place a

Latch

mat under the treadmill. Keep the treadmill out of di-

rect sunlight. Do not leave the treadmill in the stor-

Knob

age position in temperatures above 85° F (30° C).

Pin

HOW TO MOVE THE TREADMILL

Frame

Before moving the treadmill, convert it to the storage position

as described above. Make sure that the frame is held se-

 

curely by the latch pin.

Handrail

1. Hold a handrail and the frame and place one foot against

one of the wheels.

 

2. Tip the treadmill back until it rolls freely on the wheels.

 

Carefully move the treadmill to the desired location. Never

 

move the treadmill without tipping it back. To reduce

 

the risk of injury, use extreme caution while moving

 

the treadmill. Do not attempt to move the treadmill

 

over an uneven surface. Do not pull back on the frame.

Wheel

3. Place one foot against a wheel, and carefully lower the

treadmill until it is resting in the storage position.

 

HOW TO LOWER THE TREADMILL FOR USE

 

1.See drawing 2. Hold the upper end of the treadmill with your right hand. Pull the latch knob to the left. It may be necessary to push the frame forward as you pull the knob to the left. Pivot the frame downward and release the latch knob.

2.See drawing 1. Hold the metal frame firmly with both hands and lower it to the floor. CAUTION: Do not grip only the plastic foot rails or drop the frame to the floor. Bend your legs and keep your back straight.

17

Image 17
Contents Model No. WLTL37309.0USERʼS Manual Serial No QUESTIONS?Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Page Before YOU Begin Do not fully fold the Frame yet AssemblyMake sure that the power cord is unplugged 96mm Bolts 5 do not fully tighten Bolts yet Upright Spacer 80. Be careful not to pinchDo not fully tighten the Bolts yet Not fully fold the Frame yetTighten the Nut the Wheel must turn freely Page Knob Spring Collar Pin PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Features of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerSelect the manual mode Insert the key into the consoleMeasure your heart rate if desired. Before using Select the duration of the workout if desired HOW to USE a Preset WorkoutHOW to USE the Crosswalk Arms Information ModeHOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USECompatible with GFCI-equipped outlets TroubleshootingProblem The power turns off during use Top Problem The walking belt slows when walked onProblem Solution Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencyKey No. Qty Description Part LIST-Model No. WLTL37309.0Key No. Qty Description Exploded Drawing A-Model No. WLTL37309.0 R0809A Exploded Drawing B-Model No. WLTL37309.0 R0809A Exploded Drawing C-Model No. WLTL37309.0 R0809A Exploded Drawing D-Model No. WLTL37309.0 R0809A Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty