Weslo 831.24822.0 manual Problem The walking belt slows when walked on

b. If the walking belt is overtightened, treadmill perfor-

b

mance may decrease and the walking belt may be-

2–3 in.

come damaged. Remove the key and UNPLUG THE

POWER CORD. Using the hex key, turn both idler

roller bolts counterclockwise, 1/4 of a turn. When the

walking belt is properly tightened, you should be able

to lift each edge of the walking belt 2 to 3 in. (5 to 7

cm) off the walking platform. Be careful to keep the

walking belt centered. Then, plug in the power cord,

Idler Roller

insert the key, and run the treadmill for a few minutes.

Repeat until the walking belt is properly tightened.

Bolts

SOLUTION: a. If the walking belt has shifted to the left, first re-

a

move the key and UNPLUG THE POWER CORD.

Using the hex key, turn the left idler roller bolt clock-

wise 1/2 of a turn. Be careful not to overtighten the

walking belt. If the walking belt has shifted to the

right, turn the left idler roller bolt counterclockwise 1/2

of a turn. Then, plug in the power cord, insert the key,

and run the treadmill for a few minutes. Repeat until

the walking belt is centered.

b. If the walking belt slips when walked on, first re-

b

move the key and UNPLUG THE POWER CORD.

Using the hex key, turn both idler roller bolts clock-

wise, 1/4 of a turn. When the walking belt is correctly

tightened, you should be able to lift each edge of the

walking belt 2 to 3 in. (5 to 7 cm) off the walking plat-

form. Be careful to keep the walking belt centered.

Then, plug in the power cord, insert the key, and care-

fully walk on the treadmill for a few minutes. Repeat

until the walking belt is properly tightened.