NVS 6
MANUAL
1 | 2 |
| |
9 | 1 | Retainer | |
2 | Tail End | ||
| |||
| 6 | Recess | |
| 9 Clamp | ||
| 6 |
| |
Assembly of Clamp with Retainer
Figure 6.2
6.1.2 Installation of Counterweight
6.1.2.1Take counterweight (10) (Ref. Fig. 3.1) from the set of spare parts, remove the backing of the sticking fastener meant for fastening to the helmet.
1
Figure 6.3
6.1.2.2Bond the removed fastener to the rear potion of the helmet external surface so that the hole made at the center of the fastener coincides with screw head
(1)(Fig. 6.3), the lower edge of the fastener therewith should join to the helmet rubber edging. Before bonding with adhesive trace the outline of the fastener on the helmet and thoroughly remove the paint from the helmet within the outline.
Page 21