NVS 6
MANUAL
required)
10.6The inspection procedure shall be performed as specified in
Table 3.
10.7The image quality shall be tested in compliance with Step 6.2.21.
10.8The screws shall be checked for proper tightness, slipping and inadvertent loosening with the aid of the screwdriver, included in the set of spare parts.
When carrying out this check, make sure that the screws completely secure the joints between parts and assemblies. Screw slippage and loosening are inadvisable.
10.9The adjustment of force of retainer (21) (Ref. Fig. 5.2) shall be accomplished by turning the retainer attachment screw.
When the screw is turned, the retaining force changes (retainer spring pressing force).
Page 49