Newcon Optik NVS 6 operation manual Nvs

Page 35

NVS 6

MANUAL

right eye, as well as clear view of the surrounding space by shifting gaze downwards under the eyepieces of the night-vision goggles.

Note – If the RH side monocular of the night-vision goggles fails to be set to the position at which the sighting line of the pilot’s eye passes through its center, the position of the RH side monocular shall be corrected by moving the night-vision goggles upwards or downwards, right or left relative to the helmet. To do so, the carriages of helmet mount

(26)should be shifted by the adjustment of screws (16) utilizing the screwdriver provided (Ref. Fig. 6.6). On completion of the corrective actions, perform the operations described in this step once again.

6.2.19Carry out the operations prescribed by Step 6.2.8 of this Manual to finally adjust the interpupilary distance.

Make sure that the full field of view of the night-vision goggles is provided for both eyes.

6.2.20Adjust the eyepieces to the appropriate dioptric sighting by turning rings (17) (Ref. Fig. 6.5) of the eyepieces until a sharp structural image of the screens on the image-intensifier tubes is attained.

6.2.21Evaluate the operational status of the night-vision goggles by checking the image quality (resolving power). For this purpose, take a test pattern, from the single set of spare parts and arrange it at a distance of an outstretched hand away from the lenses ((750±16) mm). The settings of the night-vision goggles are considered to be normal if the test pattern lines are clearly visible and the check text is readable. Both monoculars should operate without flashes and twinkling.

CAUTION: THE SERVICEABILITY CHECK OF THE NIGHT- VISION GOGGLES SHALL BE ACCOMPLISHED IN THE PRESENCE OF LIGHT WITH THE LENSES COVERED BY THE SAFETY CAPS.

6.2.22De-energize the night-vision goggles (Ref. Step 6.2.9 of this

Manual).

Page 30

Page 34 Page 36
Image 35
Page 34 Page 36
Contents NVS NVS Manual List of Effective Pages Manual General NVS Main Data NVS Standard SET NVS 6 Standard Set Safety Precautions Design of Unit and ITS Components NVS NVS Manual NVS NVS NVS LVG Screw Guides Spring Carriage NVS NVS Preparation of Helmet for Mounting Night-Vision Goggles Preparation for OperationReplacement of Casing on Helmet Retainer Individual Adjustment and Fitting Figs 6.4 thru NVS NVS Night-Vision Goggles Installed on Helmet in Stowed Position Button Lever Knob Guide Mount Plate Retainer Cable Helicopter Electrical System Connector NVS NVS NVS NVS Arrangement of Night-Vision Goggles on Helicopter Figs Thru NVS NVS NVS Operation Procedure NVS Operational Status Check Trouble Shooting NVS Trouble Probable Remedy Remarks Cause NVS NVS NVS Maintenance Practices NVS NVS NVS NVS Storage and Shipment Appendix a Appendix B Warranty NVS
Top Page Image Contents