Sears NTL99011.2 user manual

13.Connect the ground wires (G), the 8-pin wires (F), the 10-pin wires (E), and the four speaker wires (H) from the Console (103). Note: The Upright Wire (81) has 8 pins, the pulse wire (E) has 10 pins, and the speaker wires (H) have 2 pins.

See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON-

NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER.

After all of the wires are connected, pull the wires tight and tighten the ties (99) around the wires. Make sure that no wires are resting on any posts other than those with wire ties. Cut off the ends of the ties.

14.Insert the Console Base Back (93) into the hole in the console assembly and onto the top of the indicated bracket. Be careful not to pinch any wires.

Tighten two #8 x 1/2" Flat Head Screws (31) into the tray on the Console Base Back (93).

13

103

E G F 81

9999

99

H

Console

Wire

81
14
	31
	Bracket
Console	93
Assembly

13