Sears NTL99011.2 user manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

•Assembly requires two persons.

•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps.

•The underside of the walking belt is coated with high-performance lubricant. After shipping, there may be some lubricant on top of the walking belt or on the shipping carton. This is normal. If there is lubricant on top of the walking belt, wipe it off with a soft cloth and a mild, non-abrasive cleaner.

•To identify small parts, see page 6.

•Assembly requires the following tools:

the included hex key one adjustable wrench one Phillips screwdriver

To avoid damaging parts, do not use power tools.

1. Make sure that the power cord is unplugged.	1
Attach the Left Wheel Cap (96) to the Base (94)
with two #8 x 3/4" Screws (2).
Attach the Right Wheel Cap (not shown) to
the Base (94) in the same way.
		94
		2
				96
2. Pull the Upright Wire (81) and the base ground	2
wire (A) through the indicated hole in the Base
(94) using the plastic tie.			Square
Attach the base ground wire (A) to the Base (94)		Hole	Hole	77
with a #8 x 1/2" Ground Screw (10).	Tie
Press the Grommet (77) into the square hole in		81
the Base (94).
See the inset drawing. Cut the plastic tie near		10
the Upright Wire (81). Be careful not to damage			A
the Upright Wire.				94
	Tie
	Cut
	81
	7