Sears NTL99011.2 user manual

Page 4

20.Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord, and press the power switch into the off position when the treadmill is not in use. (See the drawing on page 5 for the location of the power switch.)

21.Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 7, and HOW TO FOLD AND MOVE THE TREADMILL on page 25.) You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

22.When folding or moving the treadmill, make sure that the storage latch is holding the frame securely in the storage position.

23.Never insert any object into any opening on the treadmill.

24.Inspect and properly tighten all parts of the treadmill regularly.

25.DANGER: Always unplug the power cord immediately after use, before clean- ing the treadmill, and before performing the maintenance and adjustment procedures described in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servic- ing other than the procedures in this manual should be performed by an authorized ser- vice representative only.

26.This treadmill is intended for home use only. Do not use this treadmill in a commercial, rental, or institutional setting.

27.Over exercising may result in serious injury or death. If you feel faint or if you experience pain while exercising, stop immediately and cool down.

SAVE THESE INSTRUCTIONS

4

Image 4
Contents Model No. NTL99011.2 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Page Before YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyUpright Wire 81. Be careful not to damage Be careful not to pinch any wires. Insert two See the inset drawing. Tie the wire tieTighten the Screws yet Attach the Right Upright not shown Base Covers into place yet Screws Tighten the ScrewsAssembly Wires Make sure none of the wires from Console are pinchedHandrails 87. Be careful not to pinch any Screws and then tighten themPage 10. Do not overtighten the Screws Page HOW to PUT on the Heart Rate Monitor Care and MaintenanceTroubleshooting Chest Heart Rate MonitorHOW to Connect the Power Cord Operation and AdjustmentUse a Surge Suppressor Console Diagram Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeFollow your progress with the displays Measure your heart rate if desiredHOW to USE AN Onboard Workout Turn on the fan if desiredSelect an onboard workout Start the workoutInsert the iFit Live module into the console HOW to USE AN Ifit Live WorkoutSelect an iFit Live workout HOW to USE the Stereo Sound System Start the workout. See onInformation Mode MetricHOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USESymptom The power does not turn on TroubleshootingSymptom The power turns off during use Symptom The walking belt slows when walked on Page Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart List Qty Description101 Left Speaker Cover Exploded Drawing aExploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT