Sears NTL99011.2 user manual HOW to Fold and Move the Treadmill, HOW to Fold the Treadmill

Page 25

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL

To avoid damaging the treadmill, adjust the incline to the lowest position before you fold the treadmill. Then, remove the key and unplug the power cord.

CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow below. CAUTION: Do not hold the frame by the plastic foot rails. Bend your legs and keep your back straight.

1

Frame

2.Raise the frame until the latch knob locks in the storage position. CAUTION: Make sure that the latch knob locks.

2

Frame

Latch Knob

To protect the floor or carpet, place a mat under the treadmill. Keep the treadmill out of direct sunlight. Do not leave the treadmill in the storage position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, fold it as described at the left. CAUTION: Make sure that the latch knob is locked in the storage position. Moving the treadmill may require two people.

1.Hold the frame and one of the handrails, and place one foot against a wheel.

1

Frame

Handrail

Wheel

2.Pull back on the handrail until the treadmill will roll on the wheels, and carefully move it to the desired location. CAUTION: Do not move the treadmill without tipping it back, do not pull on the frame, and do not move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill.

HOW TO LOWER THE TREADMILL FOR USE

1.See drawing 2. Hold the upper end of the tread- mill frame with your right hand. Then, pull the latch knob to the left. IMPORTANT: Do not turn the latch knob. If necessary, push the frame forward slightly. Pivot the frame downward a few inches, and release the latch knob.

2.See drawing 1 at the left. Hold the metal frame firmly with both hands, and lower it to the floor.

CAUTION: Do not hold the frame by the plastic foot rails, and do not drop the frame. Bend your legs and keep your back straight.

25

Image 25
Contents Model No. NTL99011.2 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Page Before YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyUpright Wire 81. Be careful not to damage Be careful not to pinch any wires. Insert two See the inset drawing. Tie the wire tieTighten the Screws yet Attach the Right Upright not shown Base Covers into place yet Tighten the Screws ScrewsAssembly Make sure none of the wires from Console are pinched WiresHandrails 87. Be careful not to pinch any Screws and then tighten themPage 10. Do not overtighten the Screws Page Care and Maintenance HOW to PUT on the Heart Rate MonitorTroubleshooting Chest Heart Rate MonitorHOW to Connect the Power Cord Operation and AdjustmentUse a Surge Suppressor Console Diagram Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerMeasure your heart rate if desired Follow your progress with the displaysTurn on the fan if desired HOW to USE AN Onboard WorkoutSelect an onboard workout Start the workoutInsert the iFit Live module into the console HOW to USE AN Ifit Live WorkoutSelect an iFit Live workout Start the workout. See on HOW to USE the Stereo Sound SystemMetric Information ModeHOW to Fold the Treadmill HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USESymptom The power does not turn on TroubleshootingSymptom The power turns off during use Symptom The walking belt slows when walked on Page Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencyQty Description Part List101 Left Speaker Cover Drawing a ExplodedExploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT