ASSEMBLY INSTRUCTIONS
| Screw hole | R |
Slot |
|
|
|
| FRONT |
|
| R |
|
| R |
L | L |
|
|
| |
| L | REAR |
STEP 19: There is an "L" decal on the LEFT LEVERAGE ARM(17), and an "R" decal on the RIGHT LEVERAGE ARM(18). Slide the RIGHT LEVERAGE ARM(18) onto the shaft at right side of the ARM BRACE(16) and secure with LARGE WASHER(M12xø31mm)(79) and NYLOCK NUT(M12x1.75)(82).
STEP 20: Attach the RIGHT WEIGHT BAR(20) to the RIGHT LEVERAGE ARM(18) with HEX BOLTS (M12x1.75x80mm)(73), WASHERS(M12)(80), and NYLOCK NUTS(M12x1.75)(82). Slide the WEIGHT COLLAR(84) onto the RIGHT WEIGHT BAR(20) and lock in position with the LOCKING KNOB(85).
NOTE: When installing the RIGHT WEIGHT BAR(20), be sure they angle up and toward rear of the machine.
STEP 21
NOTE: The inset drawing in the above illustration shows detailed assembly of the RIGHT HANDLEBAR(22) pivot. For instructional purposes the BEARING(27) and the BEARING SPACER(28) are shown unassembled in the illustration; however, your Viper arrives with these parts preassembled. Turn the BEARING SPACER(28) until you can see the hole inside the slot in the RIGHT LEVERAGE ARM(18). Now you are ready to assemble the LEFT and RIGHT HANDLEBARS(21, 22). Do not overtighten.
Verify the location of the screw hole in the RIGHT HANDLEBAR(22). Insert the shaft on the RIGHT HANDLEBAR(22) into the RIGHT LEVERAGE ARM(18). Align the hole in the BEARING SPACER(28) and the screw hole in the RIGHT HANDLEBAR(22). Then bolt the SOCKET HEAD BOLT(M6x1x20mm)(65) onto the RIGHT HANDLEBAR(22). Secure the RIGHT HANDLEBAR(22) to the RIGHT LEVERAGE ARM(18) with LARGE WASHER(M12xø31mm)(79) and NYLOCK NUT(M12x1.75)(82).
Repeat the above assemblies for left side.
12