Assembly Instructions

STEP 5

Remove the paper covering from the foam tape inside the FRONT COVER(7) and REAR COVER(8). Place the FRONT COVER(7) over the FRONT FRAME(1). Place the REAR COVER(8) over the REAR FRAME(2). Press the covers securely in place.

NOTE: The securing SCREWS(M6x1x35mm)(42) for the PULLEY ASSEMBLY(26) on each side may need to be loosened to allow the REAR COVER(8) to fit securely over the frame. Refer to the inset drawing A. When retightening the screws for the PULLEY ASSEMBLYS(26) do not over tighten. The PULLEY ASSEMBLYS(26) should move freely.

STEP 6

Refer to the above illustration. Make sure that the threaded holes in the FOOT REST(10) are facing toward the end of the AeroPilates Performer XP615 as shown. Insert the FOOT REST(10) into the mounting holes located in the FRONT COVER(7) and FRONT FRAME(1). Insert the FOOT REST(10) all the way to the bottom and lock it in place with the LOCKING KNOBS(55).

NOTE: You can choose to insert the CARDIO REBOUNDER(56) into the FRONT FRAME(1) and lock in position with the LOCKING KNOBS(55). Refer to the inset drawing B.