Smooth Fitness 9.1 SERIES instruction

Using a Heart Rate Transmitter (HR Models)

How to wear your wireless chest strap transmitter:

1.Attach the transmitter to the elastic strap using the locking parts.

2.Adjust the strap as tightly as possible as long as the strap is not too tight to remain comfortable.

3.Position the transmitter with the logo centered in the middle of your body facing away from your chest (some people must position the transmitter slightly left of center). Attach the final end of the elastic strap by inserting the round end and, using the locking parts, secure the transmitter and strap around your chest.

4.Position the transmitter immediately below the pectoral muscles.

5.Sweat is the best conductor to measure very minute heart beat electrical signals. However, plain water can also be used to pre-wet the electrodes (2 black rectangu- lar areas on the reverse side of the belt and either side of transmitter). It’s also recommended that you wear the transmitter strap a few minutes before your work out. Some users, because of body chemistry, have a more difficult time in achieving a strong, steady signal at the beginning. After “warming up”, this problem lessens. As noted, wearing clothing over the transmitter/strap doesn’t effect performance.

6.Your workout must be within range - distance between transmitter/receiver - to achieve a strong steady signal (as noted by flashing light). The length of range may vary somewhat but generally stay close enough to the console to maintain good, strong, reliable “flashes” (pulses).

Wearing the transmitter immediately against bare skin assures you of proper operation. If you wish, you may wear the transmitter over a shirt. To do so, moisten the areas of the shirt that the electrodes will rest upon.

Note: The transmitter is automatically activated when it detects activity from the user’s heart. Additionally, it automatically deactivates when it does not receive any activity. Although the transmitter is water resistant, moisture can have the effect of creating false signals, so you should take precautions to completely dry the transmitter after use to prolong battery life (estimated transmitter battery life is 2500 hours). Use Panasonic no. CR2032 / 3 volt for replacement battery.

Page 16