Operating Features

Pause Feature:

Workouts may be paused at any time, during either manual or program operation. During a pause, Time and Distance will be held. Speed and Incline may be adjusted while paused.

1.Press [STOP/PAUSE]. The treadbelt slowly decelerates to zero mph.

2.Press [START BELT] to resume workout at previous settings.

Pace Feature:

Your pace is the amount of time that it will take to walk or jog a mile. When selected, your pace in minutes and seconds will display in left hand window and adjust up or down as speed is changed.

1.While treadbelt is moving, press [SELECT] until the word PACE appears in the left hand window. In a few seconds, your pace is computed and displayed in the left hand window.

Incline Feature:

The Incline may be adjusted anytime the display is lit. A small “dot” (light) will flash as incline motor is raising / lowering treadmill. This is a diagnostic device indicating the upper display is receiving an input signal from lower electronics.

1.Press and hold the [INCLINE +/-]the keys to achieve desired level of effort.

Panel Dim Feature:

The Panel Dim feature is available when the belt is moving and will blank out the display. After belt movement, pressing [PANEL DIM] will blank out the display. Pressing any other key while dimmed will “wake” the display back up for a few seconds.

1.Press [PANEL DIM] to blank out the display. Press again to cancel.

Track Feature:

The center display window can display your progress on a simulated 1/4 mile track, using a blinking dot on the track to show your location. The left hand window will display the num- ber of laps.

1.Before belt movement, press [SELECT] until a large oval is displayed in the center window.

2.Press [START BELT] to begin.

Page 10