JVC RX-554VBK manual Connecting the subwoofer, Audio component connections

Page 11

Connecting the subwoofer

Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs.

SUBWOOFER

OUT

Powered subwoofer

Connecting Audio/Video Components

You can connect the following components to the receiver using cables with RCA pin plugs.

Audio Components

Video Components

•

Turntable

•

VCR

•

CD player

•

Video disc player

 

 

 

 

•

Cassette deck

•

TV

CAUTION:

If you connect a sound-enhancing device such as a graphic equalizer between the source components and this receiver, the sound output through this receiver may be distorted.

Audio component connections

If a ground cable is provided for your turntable, connect the cable to the GND terminal of the AM LOOP terminals on the rear panel.

ANTENNA

FM 75

FM

GND

GND PHONO CD

AM

LOOP

AM

EXT

Turntable

To audio output

To audio output

 

 

 

 

 

 

 

OUT

 

 

 

IN

 

 

 

 

 

 

 

(REC)

 

(PLAY)

 

 

 

 

VIDEO

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

VCR

 

 

 

 

 

 

 

 

 

 

 

 

 

 

TAPE

 

 

 

 

 

 

 

 

 

 

OUT

 

IN

 

OUT

 

 

IN

(REC)

(PLAY)

(REC)

(PLAY)

CD player

MONITOR

OUT

AUDIO

LEFT

RIGHT

Note:

Any turntables incorporating a small-output cartridge such as an MC (moving-coil type) must be connected to the receiver through a commercial head amplifier or step-up transformer. Direct connection may result in unsufficient volume.

To audio output

To audio input Cassette deck

8

Page 10 Page 12
Image 11
Page 10 Page 12
Contents RX-554VBK To Reduce the Risk of Electric Shock Center Speaker Level Rear Speaker Level Effect Level For actual setting procedures, see pages 22 toTable of Contents Front Panel Remote ControlParts Identification RX-554VBK Easy Set Up & OperationsTurn on the power Handling the receiver Getting StartedGeneral LocationsAM Antenna Connections Connecting the FM and AM AntennasFM Antenna Connections Getting Started Connecting the front speakersConnecting the rear and center speakers Connecting the SpeakersAudio component connections Connecting the subwooferConnecting Audio/Video Components If your audio components have a Compu LINK-3 terminals Video component connectionsPutting Batteries in the Remote Control Connecting the Power CordOn the front panel From the remote controlTurning the Power On and Off Basic OperationsSelecting the Front Speakers From the remote control onlyAdjusting the Volume On the front panel onlyRecording a Source Listening with HeadphonesTo listen with only headphones Basic OperationsUsing the Sleep Timer Basic SettingsAdjusting the Front Speaker Output Balance Listening at Low Volume LoudnessSelecting the Center Speaker Size Basic SettingsWhen the shut-off time comes To cancel the Sleep TimerOne Touch Operation To store the sound settingsTo recall the sound settings To cancel the One Touch Operation functionReceiving Radio Broadcasts Tuning in Stations ManuallyUsing Preset Tuning To store the preset stationsPress 10 keys to select a preset channel number To cancel a stored preset stationTo tune in a preset station Press Control @/ # to select a preset channelPress TUNER/BAND so that the Control %/ Þ/ @ Selecting the FM Reception Mode#buttons work for tuner settings Receiving Radio BroadcastsTo cancel the preset SEA mode Using the Preset SEA ModesSelecting Your Favorite SEA Mode Press SEA Preset to select the effect level Using the Preset SEA ModesOn surround modes On JVC 3D Phonic modeOn the DAP mode Activating the Surround Sounds3DTHEATR Using JVC 3D-PHONIC ModesActivating the Surround Sounds 3DACTIONPress Effect to select the effect level Press Control @ / #to adjust the effect levelTo cancel the 3D-PHONIC mode Hall Using the DAP ModesPavilion Press Rear +/- to adjust the rear speaker output level Press Control @/ #to adjust the rear speaker output levelTo cancel the DAP mode Select OFF in step DAP indicator goes off from the displayThis case Select Prologic or Theater Select Phantom for center modeSelect 3CHLOGIC Select Normal or Wide for center mode Speaker Arrangements for Surround Modes3CHLOGIC Preparing for Surround ModesPrologic TheaterNormal Press Control @/ # to select the center modeDelay WideDelay 1 Delay 2 Delay If necessary, adjust the speaker output balance as followsPress Test again to stop the test tone Press Effect to adjust the effect levelPress Test to start checking the speaker output BalanceSelect OFF in above Using Surround ModesTo cancel surround mode From the front panelSynchronized Recording Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Automatic Source SelectionStarts playback To operate JVC audio components using this remote controlOperating Other Components Starts playingYou can always perform the following operations on the TV Operating Other ComponentsProblem Possible Cause Solution TroubleshootingAmplifier SpecificationsGeneral FM tuner IHFAM tuner HOW to Locate Your JVC Service Center Limited Warranty AUDIO-2 1297OFMMDWJEM

RX-554VBK specifications

The JVC RX-554VBK is a versatile and feature-rich AV receiver that caters to the needs of modern home theater enthusiasts. With its sleek design and robust build quality, this receiver is designed to deliver exceptional audio and video performance, making it an ideal addition to any entertainment setup.

One of the standout features of the JVC RX-554VBK is its multi-channel surround sound capability. The receiver supports 5.1 channel audio, which creates an immersive soundscape that enhances movie watching and gaming experiences. With a total output power of 100 watts per channel, it’s powerful enough to fill medium to large rooms with rich, clear sound.

The RX-554VBK is equipped with several advanced audio processing technologies, including Dolby Pro Logic II and DTS. These technologies effectively decode surround sound formats, allowing users to enjoy films and music with remarkable audio fidelity. Additionally, the receiver is compatible with various audio formats, including MP3, WMA, and FLAC, ensuring versatile playback options for digital music lovers.

Connectivity is another highlight of the JVC RX-554VBK. It features multiple HDMI inputs, allowing users to connect various devices such as Blu-ray players, gaming consoles, and streaming devices easily. The HDMI interface supports 4K video pass-through, enabling seamless integration with the latest Ultra HD televisions and projectors. Furthermore, the receiver includes component and composite video inputs, ensuring compatibility with a wide range of older and newer devices.

The on-screen display simplifies navigation through the receiver’s features, making it user-friendly for both novices and seasoned users. Additionally, the RX-554VBK supports a range of listening modes, allowing users to customize their audio experience according to their preferences, whether they're watching a movie, listening to music, or gaming.

For those who value ease of use, the JVC RX-554VBK comes with a remote control, allowing users to conveniently adjust settings from across the room. Its compact size makes it suitable for various settings without compromising on performance or features.

In summary, the JVC RX-554VBK is a powerful and user-friendly AV receiver that delivers impressive audio and video quality. Its extensive connectivity options, advanced audio processing technologies, and customizable settings make it an excellent choice for anyone looking to elevate their home entertainment experience. With the RX-554VBK, users can enjoy movies, music, and games in superior clarity and surround sound, making it a top contender in the home theater market.
Top Page Image Contents