JVC RV-NB20W, RV-NB20B manual „ Listening to the iPod

Page 62

„Listening to the iPod

4 x

iPod 6

iPod 6

x

4

You can operate an iPod through the system.

•Before connecting your iPod to the system, check its type and software version (see page 4).

•Remember you cannot send any data to your iPod from the system.

•You can also operate the iPod directly even while it is connected to the system. For details of the operation, refer to the instructions of your iPod.

CAUTIONS:

•The iPod battery is charged while the system is turned on. See the iPod instruction manual about charging times.

•Sound distortion may occur when playing back audio sources with high recording levels. Adjusting the iPod’s equalizer to “Flat” is recommended. For information on operating the iPod, see the iPod instruction manual.

•JVC is not responsible for any loss of or damage to iPod that might result from the use of this product.

•When you connect your iPod to the cable, make sure it connects all the way in.

•Do not carry the system with iPod connected. You might drop it down or it might cause damages to the connector part.

•Do not touch or hit the iPod terminal pins or the connector pins directly. It might cause damages to the connector part.

•Remove the iPod from the cable when you do not use.

Playing the iPod

To play the iPod

„1. Set the volume level to minimum. „2. Press iPod 6.

The iPod is turned on and starts playing.

iPod indicator

(After 2 seconds)

„3. Adjust the volume to the desired listening level.

To pause, press iPod 6.

To cancel pause, press the same button again. Playback continues from the point where it was paused.

Skip Play

Press 4 or x to select the track you want to play during playback.

•Press x once to skip to the beginning of the next track.

•Press 4 to skip to the beginning of the track being played. Press 4 twice quickly to skip to the beginning of the previous track.

You can also select a track with the same buttons while the iPod is paused.

To start playback, press iPod 6.

Search Play

Press and hold 4 or x to fast forward/ reverse the track during playback.

You can quickly find a particular passage in the track you are listening to. During search play, you can hear the sound of approx. one forth level.

NOTE:

When iPod is selected as the source...

–“CONNECT” appears on the display with the iPod connected.

–“NO CONNECT” scrolls on the display without the iPod connected.

Turning off the iPod

Press and hold iPod 6 for about 2 seconds.

•Turning off the system* or changing iPod to another source also turns off the iPod.

*Turning off the system may not turn off the iPod depending on the current source.

About the battery charge of the iPod

•When the system is operated on the AC power:

The iPod battery is always charged except while FM/AM is selected as the source.

•When the system is operated on the batteries or the car battery (DC12V):

The iPod battery is charged only while the system is turned on without FM/AM selected as the source.

–The iPod battery will not be charged while “DC OFF” is flashing on the display (see page 6).

13

Page 61 Page 63
Image 62
Page 61 Page 63
Contents RV-NB20B/RV-NB20W Mises en garde, précautions et indications diverses Important for Laser Products „ Table of contents „ Index of parts and controls Display window„ Getting started Remote controlAccessories Compu Play One Touch OperationChecking the type of your iPod Using the remote control RM-SRVNB20ACarrying the system Compatible iPod typesConnections Rear viewFront view Disconnecting the iPodDisconnecting the auxiliary equipment „ Basic operations Turning the power on and offAdjusting the volume Press ON/STANDBYTurning off the sound temporarily Adjusting the super woofer volumeSelecting the sound mode Activating clear sound„ Listening to the radio Tuning in to a station„2. Select a station using one of the following methods „1. Press FM/AM repeatedly to select either FM or AMTo change the preset stations, repeat the same steps as Presetting stationsSetting a disc „ Playing back discsPress the number buttons to directly play a track Using the disc player-Normal Play„1. Set a disc. „2. Press CD Repeating tracks Programming the playing order of the tracksRandom play Turning off the iPod „ Listening to the iPodPlaying the iPod Listening to auxiliary equipment Switching to AUX automatically-QP Link„ Listening to auxiliary equipment Changing the AUX jack sensitivitySetting the clock „ Using the microphone/guitar„ Using the timer Setting the sleep timerSetting the daily timer Symptom Possible cause Action „ Care and maintenance„ Troubleshooting „ Specifications SymptomFor U.S.A For U.S.A RV-NB20B/RV-NB20W Powered Woofer CD System Manuel D’INSTRUCTIONS Mises en garde, précautions et indications diverses Important for Laser Products „ Table of contents „ Index of parts and controls Group UP, Group Down Carrying the system „ Connecting the microphone/guitar „ Connecting the iPod See Counterclockwise to decrease the volume Turn the Volume +/- control clockwise toIncrease the volume or turn it Played „ Listening to the radio „ Playing back discs Set a disc Press CD Using the disc player-NormalPlay Tracks will play in no special order when you use this mode „ Listening to the iPod „ Listening to auxiliary equipment „ Using the microphone/guitar Setting the daily timer „ Care and maintenance Disc Player Tuner EN, FR LVT1614-003B B RV-NB20B/RV-NB20W Information for Users on Disposal of Old Equipment Above ALL„ Table of contents „ Index of parts and controls „ Getting started R6SUM-3/AA15F supplied Connections To dock connector IPod stand supplied IPod not supplied „ Basic operations Turning off the sound temporarily „ Listening to the radio „ Playing back discs Using the disc player-Normal Play Programming the playing order of the tracks „ Listening to the iPod „ Listening to auxiliary equipment „ Using the microphone/guitar „5. Set the OFF time example „ Care and maintenance Phones 0906KMMMDWJEIN
Top Page Image Contents