S T E P 5 B L A C K B A G
•Secure top and bottom shield brackets QO5) to weight stack tower (AB1) using bolts (M5x10), flat washers (5.2x10x1.5), and lock washers (5.1x9.3x1.3) provided. Repeat for all side brackets (QO4).
•Place two rubber weight plate bumpers (K10) over the holes in the lower cross tube of the weight stack tower. With the horizontal holes of the guide rods at the bottom, place them over and through the rubber weight plate bumpers into the weight stack tower. Let the guide rods tilt outward from the tower. Slide each of the 20 weight plates (K02) over both of the guide rods on top of one another. Place the header weight plate (K01) over both guide rods on top of other weight plates.
•Slip the rubber guide rod sleeves (K11) over the top of the guide rods, then snap into holes in the weight stack tower. Lift the guide rods into top of weight stack tower until holes in the guide rod are lined up with the horizontal holes at the top of the weight stack tower. Insert a bolt (M8x62) and flat washer (8.4x15.5x1.6) through each guide rod and fasten with a flat washer (8.4x15.5x1.6) and a nut (M8).
15