S T E P 1 ORANGE BAG
•Slide the sliding seat bottom assembly (AH1) onto the sliding seat support tube (AH2), rollers first. Disengage pull pin of seat bottom assembly until it locks into one of the range of motion holes in the support tube.
•Set main floor support (AC1) on the ground, with curved end up, and place sliding seat support tube so that holes in the end of the floor support line up with the holes on the sliding seat support tube. Attach using two bolts (M10x70), four flat washers (10.2x22x2), and two nylon nuts (M10).
•Place the seat back support post (AT3) over the opposite end of the sliding seat support tube (AH2), aligning the holes in all three frame sections. Thread two bolts (M10x20) and two flat washers (10.2x22x2) through top of seat back support post. Do not place any bolts through other holes, as it will be done in the following step!
11