Star Trac E- UB 8100, E- RB 8110 Install the Display Weldment, Install Adjustable Heart Rate Bar

2. Install the Display Weldment

NOTE: You will need someone to assist you to install the display weldment. Have the person who is assisting you hold the display weldment while you route the display cables and connect the neck.

Have your helper hold the neck tube close to the base, route the main I/O cable, auxiliary power and coaxial cable up the full length of the display neck then make sure the contact heart rate cable is clear before seating the neck on the base. The See Figure 2a. Secure the neck tube with 4 M8 allen head bolts and washers and torque of 8-10 lbs-ft.

Step 2a

Step 2

3. Install Adjustable Heart Rate Bar

Locate the adjustable heart rate bar. Connect the cable from the hole in the neck tube to the cable from the adjustable heart rate bar.

Step 3a

Taking care to not pinch the cable assemble, mount the adjustable heart rate bar to the neck tube with four M6 x 25 mm allen bolts and four star washer. Tighten all four bolts to a torque of 8-10 lbs-ft.

Check the adjustable heart rate bar for proper operation by pressing the red button and sliding the heart rate bar back and forth to verify normal operation without difficulty.

Step 3b