PROBLEM: The walking belt is
SOLUTION: a. If the walking belt has shifted to the left, first re- move the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left rear roller adjust- ment bolt clockwise, and the right bolt counterclock- wise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.
a
b. If the walking belt has shifted to the right, first re- move the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left rear roller adjust- ment bolt counterclockwise, and the right bolt clock- wise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.
b
c.If the walking belt slips when walked on, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller adjustment bolts clockwise 1/4 of a turn. When the walking belt is cor- rectly tightened, you should be able to lift each side of the walking belt 3 to 4 inches off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key and carefully walk on the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.
c
PROBLEM: The
SOLUTION: a. Remove the key from the console and unplug the power cord.
Remove Sideshield A (60) from the right side of the treadmill by pressing down on the top of the Side- shield and then pulling it away from the Motor Hood (39). Remove Sideshield A (60) from the left side of the treadmill by pressing down on the top and then pulling it towards the Motor Hood. Next, remove the three Screws (43) from Sideshield B (59) on each side of the treadmill and remove both Sideshields.
Remove the Screws (not shown) from the Motor Hood (39). Carefully remove the Motor Hood.
Locate the Reed Switch (17) and the Magnet (12) on the left side of the Pulley (11). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8Ó. If necessary, loosen the Reed Switch Screw
(26)and move the Reed Switch slightly. Retighten the Screw. Reattach the Motor Hood (39) and run the tread- mill for a few minutes to check for a correct speed read- ing. Reattach the four Sideshields (59, 60).
| 39 |
|
60 |
|
|
|
| 59 |
59 |
|
|
| 43 | 60 |
|
| |
1/8Ó |
| 11 |
26 |
| |
|
| |
17 |
| 12 |
Top |
|
|
View |
|
|
26