Image IMTL11905.0 Distance/Incline dis, Calories/Pulse, Speed display-This, Pace/Time display

Distance/Incline dis-

play—This display shows the distance that

you have walked or run and the incline level of

the treadmill. The display

will change from one number to the other every few seconds. Note: Each time the incline changes, the display will show the incline setting for several seconds.

Calories/Pulse

display—This display shows the approximate number of calories you have burned. The dis-

play will also show your

heart rate when you use the handgrip pulse sen- sor or the chest pulse sensor. The display will change from one number to the other every few seconds.

Speed display—This

display shows the speed of the walking belt.

Note: The console can

display speed and dis- tance in either miles or kilometres. To find which unit of measurement is

selected, hold down the

Stop button while inserting the key into the con- sole. An “E” for English miles or an “M” for metric kilometres will appear in the Speed display. Press the Speed increase button to change the unit of measurement. When the desired unit of measure- ment is selected, remove the key.

Pace/Time display—

When the manual mode or the iFIT.com mode is selected, this display will show your current pace,

in minutes per mile, and

the elapsed time. The display will change from one number to the other every few seconds. When a program is selected (except for the Self Select heart rate program), the display will show the elapsed time and the time remaining in the pro- gram.

To reset the displays, press the Stop button, re- move the key, and then reinsert the key.

6 Measure your heart rate if desired.

Note: If you use
the handgrip
pulse sensor and
the chest pulse
sensor at the
same time, the
console will not	Contacts
display your
heart rate accu-

rately. Before using the handgrip pulse sensor, re- move the clear plastic film from the metal con- tacts. In addition, make sure that your hands are clean.

To use the handgrip pulse sensor, first make sure that your hands are clean. Next, stand on the foot rails and hold the handgrip pulse sensor, with your palms on the metal contacts. Avoid moving your hands. When your pulse is detected, two dashes (– –) will appear in the Calories/Pulse display, and then your heart rate will be shown.

For the most accurate heart rate reading, con- tinue to hold the contacts for about 15 sec- onds.

7 Turn on the fan if desired.

To turn on the fan, press the button below the fan. To turn on the fan at high speed, press the button a second time. To turn off the fan, press the but- ton a third time. Note: A few minutes after the walking belt is stopped, the fan will automatically turn off.

When you are finished exercising, remove the

8 key from the console.

Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when the treadmill is folded to the storage posi- tion or the treadmill will be damaged. Next, re- move the key from the console and put it in a se- cure place. Note: If the displays and various indi- cators on the console remain lit after the key is removed, the console is in the “demo” mode. See page 24 and turn off the demo mode.

When you are finished using the treadmill, move the reset/off circuit breaker to the off po- sition and unplug the power cord.

12