4.3WORKOUT DESCRIPTIONS
GO SYSTEM-QUICK START
This is the fastest way to begin exercising, and it bypasses the steps involved in selecting a specific workout program. Press one of the GO
| English Units | Metric Units |
WALK | 3.0 mph | 5,0 kph |
JOG | 5.0 mph | 8,0 kph |
RUN | 7.0 mph | 11,0 kph |
These speeds can be changed. To do so, use the SPEED ARROW keys to adjust the speed value displayed in the MESSAGE CENTER. Then, press, and hold down the WALK, JOG, or RUN key until the console beeps twice, indicating that the new speed has been programmed. When the WALK, JOG, and RUN keys are used to select, or change, a speed, the MESSAGE CENTER displays the new speed.
NOTE: All changed preset values are lost when the treadmill is turned off or unplugged.
HILL
The Life
The HILL workout goes through four phases, each marked by different intensity levels. The WORKOUT PROFILE window displays the progress of these phases. As noted in the descriptions below, although this is not a heart rate interactive program, the heart rate should be measured at two stages in the workout to gauge its effectiveness.
Wear the chest strap.
1
2Plateau increases the intensity slightly, and keeps it steady, to bring the heart rate to the low end of the target zone. Check the heart rate at the end of this phase.
3Interval Training is a series of increasingly steeper hills, alternating with valleys, or stints of recovery. The heart rate should rise to the high end of the target zone. Check the heart rate at the end of this phase.
4
TERRAIN (HILLS AND VALLEYS)
PLATEAU |
| INTERVAL TRAINING |
| ||
|
|
|
|
|
|
| FIRST HR |
| SECOND HR | ||
| CHECK POINT |
| CHECK POINT |
Each column, as seen in the WORKOUT PROFILE WINDOW and the chart above, represents one interval. The overall duration of the workout determines the length of each interval.
18