Life Fitness M051-00K59-0011 REV A Setup, Supply Voltage VAC Frequency Hz Maximum Current Amps

Page 21

4 SETUP

ELECTRICAL REQUIREMENTS

Most Life Fitness treadmills are intended for use on a normal 120 volt circuit in the United States and Canada. Below is a table that provides the current rating for this product based on supply voltage. Make sure that the treadmill model supports the proper line voltage for the installation location before plugging into the outlet.

Supply Voltage (VAC)

Frequency (Hz)

Maximum Current (Amps)

 

 

 

120

50 / 60

12

230

50 / 60

10

ELECTRICAL GROUNDING REQUIREMENTS

This Life Fitness product must be properly grounded. If the unit malfunctions or breaks down, proper grounding provides the path of least resistance for the electric current, which reduces the risk of shock to anyone touching or using the equipment. Each unit is equipped with an electrical cord, which includes an equipment grounding conductor and a grounding plug. The plug must be inserted into an outlet that has been properly installed and grounded in accordance with all local codes and ordinances. A temporary adapter must not be used to connect this plug to a two-pole receptacle in North America. If a properly grounded, correct amperage outlet is not available, a qualified electrician must install one.

DANGER: A risk of electrical shock may result from improper connection of the equipment’s grounding conductor. Check with a qualified electrician if you are unsure about proper grounding techniques. Do not modify the plug provided with this product. If it will not fit an electrical outlet, have a proper outlet installed by a qualified electrician.

TURNING THE UNIT ON

To turn the treadmill on, locate the ON/OFF power switch at the front of the treadmill near the power cord and switch it to ON.

HOW TO STABILIZE THE LIFE FITNESS TREADMILL

After placing the unit where it will be used, check its stability. If there is even a slight rocking motion or the unit is not stable, determine which stabilizing leg is not resting on the floor. To adjust, turn the STABILIZING LEG (A) motion ceases and both stabilizing legs rest firmly on the floor.

Note: It is extremely important that the stabilizing leg be correctly adjusted for proper operation.

CHECKING THE BELT

After the treadmill has been installed and stabilized, the belt must be checked to confirm proper tracking. First, ensure the power cord is plugged into a suitable outlet, as described in the above Electrical Requirements section. Then turn the treadmill on. Stand on the side rails of the treadmill and straddle the belt. To start the belt, press the WALK key, then press the SPEED UP arrow key until the treadmill reaches 4.0 mph/ 6.4 kph. If the striding belt appears off-center, see the instructions in Tracking (Centering) An Existing Or New Striding Belt in Section 7.3.

Note: Normal belt operating position is for the belt to be located between the aluminum extrusions (see illustration to the right). If the belt is not in this position, see Tracking (Centering) An Existing Or New

Striding Belt in Section 7.3.DETAIL A

SCALE 1 : 6

A

A

8.25

19

Image 21
Contents T5 Treadmill Page Corporate Headquarters Table of Contents Page Page Important Safety Instructions Page Consignés DE Sécurité Importantes Page T5 with Track Console Life Fitness T5 Treadmill Design IllustrationUnpacking AssemblyComponent List and Hardware Page Finger tighten bolts Do not Pinch ANY Wires Page Do not Pinch ANY Wires 100 Calibration Supply Voltage VAC Frequency Hz Maximum Current Amps SetupActivity Zone and Heart Rate Sensor Overview Flexdeck Select Feature Troubleshooting Service and Technical DataManual Weekly Preventive Maintenance TipsHOW to Adjust and Tension the Striding Belt HOW to Obtain Product Service Using and Testing the Safety Stop Pull CordPhysical Dimensions SpecificationsModel Limited Lifetime Years Warranty Information