TRACKING (CENTERING) AN EXISTING OR NEW STRIDING BELT
1.Locate the two access holes to the BELT TENSIONING BOLTS on each of the rear roller guards. These tensioning bolts make it possible to adjust tracking and centering of the striding belt without removing the guards.
2.Stand on the sides of the treadmill and straddle the belt. Enter the MANUAL Workout and set the belt speed to run at 4.0 mph (6.4 kph).
3. If the striding belt has moved to the right, turn the right tension bolt 1/4 turn clockwise with the provided 6MM Hex Key Wrench, and then turn the left tension bolt 1/4 turn
4.If the striding belt has moved to the left, turn the left tension bolt 1/4 turn clockwise and then turn the right tension bolt 1/4 turn
tart striding belt tracking back to center of roller. Repeat adjustments until the striding belt appears centered. Allow the machine to continue running for several minutes to observe if tracking remains stabilized.
Note: Do not exceed one full turn of the adjusting screws in either direction. If after one full turn the belt does not track properly, contact Customer Support Services.
TENSIONING AN EXISTING STRIDING BELT
Under normal usage, the treadmill striding belt may stretch slightly. If the belt starts to slip during use, take the steps listed below to correct the tension.
1.Using the STOP key, stop the treadmill.
2.Turn the belt tensioning bolts clockwise a
3.Set the treadmill at
Note: Do not overtighten the tensioning bolts while making belt adjustments. Overtightening of bolts may over stretch and damage the striding belt or roller bearings. Do not exceed one full turn of either bolt in either direction.
7.4USING AND TESTING THE SAFETY STOP PULL CORD
During operation of the treadmill, the lanyard on the Safety Stop Pull Cord should be attached to an item of the user’s clothing. While the treadmill is on and the console display is active, remove the Safety Stop Pull Cord from the treadmill. A message shall be displayed on the console similar to “EMERGENCY STOP - REPLACE KEY”. With the Safety Stop Pull Cord removed no keys shall function on the treadmill.
Place the Safety Stop Pull Cord back in place. The treadmill will reset and will be ready for operation.
7.5HOW TO OBTAIN PRODUCT SERVICE
1.Please contact your dealer or Life Fitness Customer Support Services at
2.Verify the symptom and review the operating instructions and troubleshooting matrix.
3.Locate and document the serial number of the treadmill. The treadmill’s serial number is located on the front of the treadmill near the power switch. Please also have proof of purchase information available.
26