Problem | Cause / Solution | |
When I try to save a workout on the |
| |
USB stick I receive the following | The console may not have recognized the USB stick. Try unplugging the USB | |
message: UNABLE TO SAVE SEE | stick and plugging it back in. The USB stick may be full. The USB stick may not | |
MANUAL. | be compatible with the product. Try using a different USB stick. | |
Note: Applies to Track Console only. |
| |
| Potential reasons for the wireless heart rate not to work properly include: | |
| 1. The wireless heart rate is turned OFF in the Settings Menu. Enter the Set- | |
| tings Menu and verify that WIRELESS HR is turned ON. | |
| 2. There is poor contact between the telemetry heart rate strap and the skin. | |
| Refer to Heart Rate Telemetry Chest Strap section in the T5 Go Console | |
| Owner’s Manual or the T5 Track Console Owner’s Manual for details. | |
The wireless heart rate is not working. | 3. There is electrical interference from electrical appliances with the telemetry | |
| heart rate strap from fluorescent lights, kitchen appliances,etc. Move the | |
| treadmill to a different location or move electrical appliances away from the | |
| treadmill. | |
| 4. The battery in the Heart Rate Telemetry Strap needs to be replaced. The | |
| battery is a CR2032 (3V). | |
|
| |
| Use of personal electronic devices, such as cell phones and portable MP3 play- | |
A heart rate reading is initially detect- | ers, causes external noise interference. Equipment is in close proximity to other | |
sources of noise such as audio/video equipment, fans, two way radios, and | ||
ed and functioning normally but then | ||
high voltage/high current power line. Remove the source of noise or reposition | ||
is lost. | ||
the exercise equipment. | ||
| ||
|
| |
| This message relates to a problem with the Incline system. If the incline has | |
| been repeatedly moved up and down in a manual program, the lift motor may | |
“OFF” is displayed in the incline | have activated a thermal protection device. Simply let the treadmill sit for 30 | |
window. | minutes and cycle power. Recalibrate the treadmill following the instructions in | |
| Section 3.3 Calibration. | |
|
| |
| The treadmill has been immobilized through software. Press the SPEED | |
“Immobilized” is displayed in window. | DOWN ARROW and STOP to exit this state. | |
|
| |
| This is displayed if your version of the iPod Player is not supported by the | |
iPod is not recognized. | treadmill. It may also be displayed if the connector on the treadmill or iPod is | |
Note: Applies to Track Console only. | damaged. | |
|
| |
iPod is not charging while in Energy | Your iPod will not charge if the treadmill enters Energy Saver mode. This is | |
Saver mode. | ||
normal. | ||
Note: Applies to Track Console only. | ||
|
23