7 SERVICE AND TECHNICAL DATA
7.1 TROUBLESHOOTING
Problem |
| Cause / Solution | |
| You may be in “Energy Saver Mode”. Press the “Energy Saver” button to see if | ||
| console turns on. | ||
|
| ||
| Check to see if the treadmill is plugged in and if the ON/OFF switch is on. If the | ||
The treadmill console does not | ON/OFF switch is on verify that the treadmill power cord is not damaged and the | ||
turn on when the ON/OFF switch is | wall outlet is functioning (tripped breaker in house). | ||
turned on. |
|
| |
| If the ON/OFF switch is on verify that all the customer assembly connections are | ||
| working properly. Unplug and | ||
| of the cables were pinched during assembly. | ||
|
|
| |
| 1. | Do not tighten the screws until the uprights, console and handrails are all | |
I am having problems bolting the |
| installed. | |
parts together when assembling the | 2. | Check the screw threads for any damage. | |
unit. | 3. | Tighten the hardware after all components are installed. | |
|
|
| |
| 1. | Turn the treadmill OFF. Make sure all assembly hardware is tightened. | |
The treadmill shakes a lot when I | 2. | If shaking still occurs, adjust the levelers under the stationary frame until the | |
run on it. |
| shaking decreases. See How to Stabilize the Life Fitness Treadmill. | |
|
| ||
| Be sure to grasp the sensors firmly and keep hands still. If heart rate seems sub- | ||
| stantially higher or lower than expected, remove hands from sensors until heart | ||
| rate disappears. Life Fitness recommends that the user stand on the side rails | ||
| when attempting to monitor heart rate with contact sensors. | ||
The contact heart rate sensors are |
|
| |
Tips for contact heart rate: | |||
not reading my heart rate correctly. | |||
1. | Dry hands to prevent slipping on the sensors. | ||
| |||
| 2. | Apply hands to all four sensors (two in each hand). | |
| 3. | Grasp the sensors firmly. | |
| 4. | Apply constant pressure to the sensors. | |
|
| ||
The running belt is tracking to the | See Tracking (Centering) An Existing or New Striding Belt. | ||
left or right. |
|
| |
The belt seems to slip when I run | You may need to tighten the walking belt. See Tracking (Centering) An Existing or | ||
on it. | New Striding Belt. | ||
|
| ||
| These messages are displayed if the Emergency Stop key is not in place on the | ||
“REPLACE SWITCH’ or | Activity Zone. | ||
“EMERGENCY STOP REPLACE | 1. | Place the key back in position. | |
KEY” displayed on the console. | 2. | If the key is in position, verify that the safety switch connector was properly | |
|
| attached to the console. | |
22