HOW to USE Preset Programs

Speed/Pace display	—
This display shows the
speed of the walking
belt and your current
pace (pace is measured
in minutes per mile	).

Every seven seconds, the display will change from one number to the other.

Note: The console can display speed and dis- tance in either miles or kilometers. To find which unit of measure- ment is selected, hold

the storage position or the treadmill will be

damaged. Next, remove the key from the console

and put it in a secure place. Note: If the displays and indicators on the console remain lit after

the key is removed, the console is in the “demo” mode. Refer to page 21 and turn off the demo mode.

When you are finished using the treadmill, move the on/off switch near the power cord to the off position and unplug the power cord.

down the Stop button whilst inserting the key into

the console. An “E,” for English miles, or an “M,” for metric kilometers, will appear in the Speed/

Pace display. Press the Speed▲ button to change the unit of measurement. When the desired unit of

measurement is selected, remove the key and

then reinsert it. Note: For simplicity, all instructions in this manual refer to miles.

To reset the displays, press the Stop button, re- move the key, and then reinsert the key.

6 Measure your heart rate, if desired.

To measure your
heart rate,	stand

Insert the key fully into the console.

See GETTING STARTED on page 10.

Select one of the three preset programs.

When the key is inserted, the manual mode will be selected and the Manual indicator will light. To se- lect one of the preset programs, press the Select button repeatedly

until the P1, P2, or P3 indicator lights.

Program Indicator

on the foot rails
and place your
hands on the metal
contacts on the
handrail. Your
palms must be rest-
ing on the upper
contacts, and your
fingers must be
touching the lower
contacts—	avoid
moving your
hands	. When your pulse is detected,	the Heart
Rate indicator will flash, three dashes (– – –) will
appear in the Heart Rate/Calories display, and
then your heart rate will be shown.		For the most
accurate heart rate reading, continue to hold
the contacts for about 15 seconds.

When you are finished exercising, stop the

7 walking belt and remove the key.

Step onto the foot rails, press the Stop button, and

adjust the incline of the treadmill to 1%. The incline must be at 1% when the treadmill is raised to

When you select a preset program, the program display will show a simplified profile of the pro- gram you have selected. For example, the profile above shows that the intensity of the selected pro- gram will be greater during the middle of the pro- gram and less during the beginning and end. The Time/Laps display will show how long the program will last.

	Press the Start Program button or the Speed	▲
3
	button to start the program.

A moment after the button is pressed, the tread-

mill will automatically adjust to the first speed and incline settings for the program. Hold the handrails and begin walking.

the storage position or the treadmill will be

damaged. Next, remove the key from the console