NordicTrack 831.298821 user manual Enter your weight if desired, +Ó button to start the program

Page 18
First Incline Setting

Refer to the LED matrix. Each INCLINE program is divided into one-minute periods. One incline setting is programmed for each period. The incline settings of the

program you have

selected are shown in the LED matrix. The two columns on

the left side of the LED

matrix will be dark. The first incline setting of the program will be shown in the third column (see the drawing above); the next seventeen incline settings are shown in the seventeen columns to the right.

5Enter your weight if desired.

When an INCLINE program is selected, the current weight setting

will flash in the INCLINE display. Although it is

not necessary to enter

your weight to use an INCLINE program, the CALORIES display will be more accurate if your weight is entered. If you have already entered your weight, or if you do not want to enter your weight, go to step 6. To enter your weight, press the WEIGHT buttons (see step 5 on page 12).

6Ò+Ó button to start the program.

When the button is pressed, the SPEED display will flash and a tone will sound twice. If the incline of the treadmill is higher than 1.5%, it will automatically decrease to 1.5%. After a moment, the walking belt will begin to move at 1.0 mph. Hold the handrails and begin walking.

Refer to the LED matrix. During the first one-minute period of the program, the first incline setting shown in the LED matrix will flash. When only three seconds remain in the first period, both the first and second incline settings in the LED matrix will flash. When the first period is completed, all incline settings in the LED matrix will move one column to the left. The second incline setting will then flash and the treadmill will adjust to the second incline setting. At the end of each one-minute period of the program, all incline settings will move one column to the left,

the next incline setting will flash, and the treadmill will adjust to the next incline setting.Press the START/ENTER button or the SPEED

The speed of the walking belt can be adjusted as desired during the program with the SPEED buttons. The TIME/PACE display will show the time remaining in the program. Near the end of the program, the walking belt will slow to allow you to cool down. During the last ten seconds of the program, the incline will decrease to 1.5%. When no time remains in the TIME/PACE display, the walking belt will slow to a stop. Note: If the RANDOM program is selected, the program will last for 60 minutes. The program can be stopped earlier, if desired, by holding down the STOP button for two seconds.

To stop an INCLINE program momentarily, press the STOP button. The displays will pause and the TIME/PACE display will begin to flash. To restart the program, press the START/ENTER button or

the SPEED Ò+Ó button. To end the program and reset the displays, hold down the STOP button for two seconds.

Note: While an INCLINE program is in progress, the difficulty level of the program can be adjusted, if desired, with the INCLINE buttons. Press the INCLINE Ò+Ó button. The letters ÒMAXÓ will appear in the LED matrix and a number will flash in the INCLINE display for three seconds. This number is the maximum incline that the treadmill will reach during the program. Press the INCLINE Ò+Ó button again. Each time the button is pressed, the maximum incline setting will increase by 0.5%. As the maximum incline setting increases, the difficulty level of the entire program will increase. The INCLINE ÒÐÓ button can be used in the same way to decrease the difficulty level of the program. Note: The incline settings shown in the LED matrix will not change; these are relative incline settings.

7Follow your progress with the six displays.

See step 8 on page 13.

8key from the console.

Make sure that the treadmill is at the lowest incline setting. Remove the key from the console. Store the key in a secure place. In addition, press

the on/off switch to the off position. (See the drawing near the top of page 12.)When the program is completed, remove the

18

Image 18
Contents Customer HOT Line Questions?Model No Serial No SEARS, Roebuck and CO., Hoffman ESTATES, ILTable of Contents Important Precautions There is one decal Before You Begin Assembly Tabs Heart Rate Monitor TROUBLE-SHOOTING How to Use the CardioTrackª Heart Rate MonitorHOW to PUT on the Heart Rate Monitor Console to display heart rate readings, the userHeart Rate Monitor Care and Maintenance Operation and Adjustment HOW to Plug in the Power CordPerformant Lubetm Walking Belt Features of the Console Enter your weight if desired HOW to USE the Manual ModePlug in the power cord Put on the Polar heart rate monitor if desiredCalories display Adjust the speed and incline of the treadmill as desiredFollow your progress with the six displays. Pulse display TIME/PACE displayIncline display DISTANCE/LAPS displayHOW to USE the Heart Rate Programs Insert the key fully into the consoleEnter your age Page Put on the CardioTrack heart rate monitor if desired HOW to USE the Incline ProgramsFollow your progress with the six displays Select one of the Incline programs+Ó button to start the program HOW to Create Custom Programs Select one of the Custom programsHOW to USE Custom Programs HOW to Adjust the Walking Platform HOW to USE the Hand WeightsHOW to Select the Information Mode How to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USE Maintenance and Trouble-shooting Symptom the Power does not Turn onSymptom the Power Turns OFF During USE Symptom the Heart Rate Monitor does not Function Properly Symptom the Walking Belt is OFF-CENTER When Walked onSymptom the Walking Belt Slows When Walked on Exercise Steps Conditioning GuidelinesFactors in a Sensible Diet Target Heart Rate ZonesWeight Loss Tips Warm up before you beginStretch after your warm-up Cool down after aerobic exercise Get FIT with the PowerTreadBenefits of Aerobic Exercise Stretchsession.again at the end of your exerciseWorkout Tips Workout ProgramsPart ListÑModel No Key No. Qty DescriptionOrdering Replacement Parts Exploded DrawingÑModel No 103 101 112 113 114 115 102 105 Limited Warranty