5.Insert the Console Wire Harness (77) and the TV cable into the Uprights (84).
Set the console assembly on the Uprights (84). Be careful to avoid pinching the wires. While a second person holds the console assembly, at- tach it with four Console Bolts (64) and four Star Washers (8) as shown; start all four Console
Bolts and then firmly tighten them.
6.Attach the Latch Housing (73) to the left Upright (84) with two Screws (3); start both Screws and then tighten them. Note: Make sure that the large hole in the Latch Housing is on the indicated side.
Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Next, insert the pin into the Latch Housing (73). Then, tighten the knob onto the pin.
5 |
Console |
Assembly |
77 |
TV Cable |
8 |
8 |
64 |
64 |
84 |
84 |
6 |
84 |
73 |
Knob 
Spring
3
Large Hole | Collar |
Pin
7.Note the location of the 75 ohm terminal on the front of the treadmill near the uprights. For the television to operate properly, a CATV cable must be connected to the 75 ohm terminal (see page 10).
7 
75 Ohm Terminal
8.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the large hex key is used to adjust the walking belt (see page 26).
8