8.Identify the Right Handrail (90), which has a large hole in the location shown. Hold the Right Handrail near the Console (87).
Insert the tie on the console wire into the large hole in the Right Handrail (90) and out of the top as shown; use needlenose pliers if necessary. Next, insert the included plastic tie through the Right Handrail as shown. Make sure that the plastic tie holds the console wire against the inner side. Then, tighten the plastic tie.
Attach the Right Handrail (90) with two M4.2 x 19mm Screws (1). Make sure that no wires are pinched. Start both Screws before tightening either of them; do not overtighten the Screws. Then, remove the plastic tie.
Attach the Left Handrail (not shown) to the Console (87) in the same way. Note: There are no wires on the left side of the Console.
9.Hold the Pulse Support (109) near the Console Base (88). Connect the Console Ground Wire (40) on the Pulse Support to the ground wire on the Console Base. Then, insert the ground wires into the Console Base and set the Pulse Support on the Console Base. Make sure that no wires are pinched.
Tighten two M4 x 20mm Screws (3) with two M4.2 Star Washers (70) into the Pulse Support (109).
Tighten the six M4.2 x 19mm Screws (1) from step 7 into the Pulse Support (109) and the Console Base (88). Start all six Screws before tightening any of them.
8 |
| Console |
| Tie | |
| Wire | |
|
| |
90 | 1 | |
|
| |
| Plastic Tie | Large Hole |
|
| |
|
| 1 |
| 87 |
|
9 |
|
|
|
| 70 |
|
| 3 |
|
| 1 |
| 1 | 88 |
| 1 |
|
3 | 109 | 1 |
70 |
|
|
|
| 40 |
|
| Ground |
|
| Wire |
10