Reebok Fitness RBTL69908.0 manual Not fully fold the Frame yet, Screws for step

5. With the help of a second person, carefully tip	5
the treadmill onto its right side. Partially fold the			B
Frame (48) so the treadmill is more stable; do
not fully fold the Frame yet.	A
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Attach a Base Pad (81) to the Base (85) in the				48
location shown with a Base Pad Spacer (104)	2	81			4
and an M4.2 x 25mm Screw (2). Then, attach a
Base Pad (81) in the location shown with only			104
an M4.2 x 25mm Screw (2).	85
Remove the M10 Nut (33), the M10 x 50mm				86
Bolt (4), and the shipping bracket (C) from the			2	81	C
Base (85). Attach a Wheel (86) with the Bolt and
				33
the Nut that you just removed. Do not over-
tighten the Nut; the Wheel must turn freely.
Discard the shipping bracket.
6. With the help of a second person, hold a Bolt	6
Spacer (79) inside the lower end of the Left
Upright (73). Insert an M10 x 96mm Bolt (5) with			5		73
an M10 Star Washer (8) into the Left Upright
and the Bolt Spacer. Repeat this step with a			8
second Bolt Spacer (79), M10 x 96mm Bolt
(5), and M10 Star Washer (8).			83
Orient the Left Upright (73) and the Left Upright
Spacer (83) as shown. Hold the Left Upright
Spacer and the Left Upright against the Base	82		79
(85). Tighten the M10 x 96mm Bolts (5) with
your fingers; do not fully tighten the Bolts yet.			85
Press a Base Endcap (82) into the Base (85).
With the help of a second person, tip the tread-
mill so that the Base (85) is flat on the floor.
7. Set the Console (87) face down on a soft sur-	7
face to avoid scratching the Console. Remove
the six M4.2 x 19mm Screws (1). Save all six
Screws for step 9.				1
Lift off the Pulse Support (109).
			1
			87
		1	109
	9