Reebok Fitness RBTL69908.0 manual Troubleshooting, Problem The power turns off during use

Page 25

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 13). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 13. IMPORTANT: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c.Check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

PROBLEM: The power turns off during use

c

Tripped

Reset

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The console displays remain lit when you remove the key from the console

SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 22 and turn off the demo mode.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE POWER CORD. With the help of a second person, carefully tip the Uprights (73, 78) down.

There may be two M4.2 x 16mm (12) in the bottom of the Belly Pan (69). If there are, remove them. Note: A Phillips screwdriver with a shaft at least 5 in. (13 cm) long is required.

a

73

 

78

69

 

12

 

12

25

Image 25
Contents Please do not Contact QUESTIONS?Call TOLL-FREE On the WEBTable of Contents Important Precautions Page Before YOU Begin Assembly Make sure that the power cord is unplugged Page Tighten the Nut the Wheel must turn freely Not fully fold the Frame yetYour fingers do not fully tighten the Bolts yet Screws for stepPage That no wires are pinched Again. if the Connectors are not CONTighten all four Bolts Small Wire Screws Cylinder 116 HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console Console DiagramHOW to Personalize Console Settings HOW to Turn on the PowerSelect the user mode Set the date and time Select a default user settingHOW to USE the Manual Mode HOW to Identify Yourself AS User 1 or UserSelect the manual mode Insert the key into the consoleChange the incline of the treadmill as desired Select a display mode and monitor yourProgress with the display Measure your heart rate if desiredSelect a personal trainer workout HOW to USE a Personal Trainer WorkoutHOW to View the Fitness Journal Select the user mode. See on Reset the fitness journal HOW to Reset the Fitness JournalExit the user mode HOW to USE the Stereo Sound SystemOptional Chest Pulse Sensor Information ModeHOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingProblem The walking belt slows when walked on Page Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches Key No. Qty Description R0208AKey No. Qty Description Exploded Drawing A-Model No. RBTL69908.0 R0208A Exploded Drawing B-Model No. RBTL69908.0 R0208A Exploded Drawing C-Model No. RBTL69908.0 Exploded Drawing D-Model No. RBTL69908.0 R0208A Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT