1.Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the treadmill onto its left side. Partially fold the Frame (48) so that the treadmill is more stable; do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A) and the shipping bracket (B).
Cut the tie securing the Upright Wire (77) to the Base (85). Locate the tie in the indicated hole in the Base, and use the tie to pull the Upright Wire out of the hole.
Attach a Base Pad (81) to the Base (85) in the location shown with a Base Pad Spacer (104) and an M4.2 x 25mm Screw (2). Then, attach a Base Pad (81) in the location shown with only an M4.2 x 25mm Screw (2).
2.Remove the M10 Nut (33), the M10 x 50mm Bolt (4), and the shipping bracket (C) from the Base (85). Attach a Wheel (86) with the Bolt and the Nut that you just removed. Do not overtighten the Nut; the Wheel must turn freely. Discard the shipping bracket.
1 |
| B |
|
| |
| 77 | A |
|
| |
|
| Hole |
|
| 2 |
48 |
| 81 |
104 | 81 | 85 |
| ||
| 2 |
|
2 |
4 |
85 |
86 |
C |
33 |
7