Cadence WCTL2982.0 user manual Assembly, Pliers, Treadmill until it is completely assembled

5

1. Make sure that the power cord is unplugged.

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor- mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches		and your own phillips screwdriver		,
rubber mallet	, wire cutters	, adjustable wrench	, and needlenose
pliers	.

To identify small parts during assembly, use the PART IDENTIFICATION CHART in the center of this manual.

1

			84
!
	31	33
!		33
		31
With the help of a second person, carefully tip the		38
treadmill onto one side. Partially fold the Frame (84) so
that the treadmill is more stable. Do not fully fold the
treadmill until it is completely assembled.
		33
Attach four Base Pads (33) to the Base (38) with four 1”		31
Tek Screws (31).
2. With the help of a second person, tip the treadmill down	2
to the position shown.
			15
		14		53
Attach a Wheel (42) to each side of the Base (38) with a
Wheel Bolt (41) and a Wheel Nut (43) as shown.
Identify the Right Upright (15) and the Left Upright (14)	Holes
(there are two small holes in the side of the Left
Upright). While a second person holds the Right Upright
near the Wire Harness (53), insert the end of the Wire
Harness into the lower end of the Right Upright and out
of the upper end as shown. If there are plastic ties in the
lower ends of the Uprights, remove them.
			38
		43
		42
		41