Healthrider HRT99020 manual Troubleshooting, Problem The power does not turn on, Position

Page 23

TROUBLESHOOTING

Most treadmill problems can be solved by following the instructions below. If further assistance is

needed, please call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppressor that meets all of the specifications described on page 8. Important: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d. Check the on/off switch located on the treadmill near the power cord. The switch must be in the on posi- tion.

PROBLEM: The power turns off during use

c
Tripped	Reset
d	On
	On
	Position

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key fully into the console.

d. Make sure that the on/off switch is in the on position.

e. If the treadmill still will not run, call our Customer Service Department toll-free.

PROBLEM: The speed display on the console does not function properly

SOLUTION: a. Remove the key and UNPLUG THE POWER CORD

Carefully lower the Uprights (64) to the floor. Remove the three indicated Small Screws (37).

Raise the Uprights (64) to the vertical position. Pivot the Hood (1) off.

.	a	64	37
	a

			64
			1

23

Image 23

Contents Customer HOT Line QUESTIONS?Model No. HRT99020 Serial No Our factoryTable of Contents Treadmill is capable of high speeds Important PrecautionsUse the treadmill only as described Page Before YOU Begin Using the treadmillInsert the other Extension Leg not shown in the same way AssemblyAssembly requires two people Driver Wire cuttersPost Insert two 1/2 Screws 33 intoScrews 105 as shown Tightly as possibleGrounded Outlet Box Surge Suppressor Grounding Pin HOW to Plug in the Power CordPerformant Lube This product must be grounded.If it should malfuncTo reduce the possibility of electric shock Console DiagramFeatures of the Console HOW to USE the Manual Mode HOW to Turn on the PowerSpeed/Min-Mile Display When the treadmill is folded to the storage posiTime/Incline/Segment Distance/Laps DisplayProgram display HOW to USE Personal Trainer ProgramsCompleted, all speed settings will move one col Start the programSelect a heart rate program HOW to USE Heart Rate ProgramsFollow your progress with the displays Put on the chest pulse sensorDecrease When the program is completed, remove Key from the consoleEnter your age Videocassettes HOW to Connect Your Portable CD PlayerHOW to Connect Your Portable Stereo Adapter Cable HOW to Connect Your Home StereoHOW to Connect Your Computer Jack on your stereoHOW to Connect Your VCR Whenkey. the program is completed, remove Next settings of the CD or video programWhen you are finished using them Ton or the SpeedSpeed HOW to USE Programs Directly from OUR WEB SiteFollowprogram.the on-line instructions to start ConsoleOptional Chest Pulse Sensor Information MODE/DEMO ModePlay should be blank If a d Buttons on the console will not operate If a d apHOW to Move the Treadmill HOW to Fold the Treadmill for StoragePin Catch HOW to Lower the Treadmill for USEHold the upper end of the treadmill with your right hand Hold the treadmill firmly with both hands, and lowerPosition TroubleshootingProblem The power does not turn on Problem The power turns off during useHas shifted to the left Magnet is aligned with the Reed SwitchSwitch is about 1/8 Problem The walking belt slows when walked onExercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Page Part No R1102A HOW to Order Replacement PartsLimited Warranty Icon Health & FITNESS, INC., 1500 S W., LOGAN, UTRemove this Exploded Drawing and Part List from the Manual Key No. Qty. Description KeyDescription No. Qty. Description Model Drawingexploded