Healthrider HRT15920 manual Turn the Receiver B so the cylinder is on the side

3. (Note: The parts shown in this step may be preassembled.)		3
	With the help of a second person, raise the Frame (55) and
	hold it. Insert the Left Frame Guide (68) into the left side of
	the Frame. Remove the Lock Knob (67) from the Lock Pin		Hole
	(72). Make sure that the Lock Pin Collar (70) and the Spring			55	10
	(69) are on the Lock Pin. Insert the Lock Pin into the Frame				5
				70
	and the Left Frame Guide. Press the Latch Insert (5) onto
				72
	the Frame, with the Lock Pin in the center hole. Tighten the
	Lock Knob onto the Lock Pin.				69	67
		68
			62
	Align the Lock Pin (72) with the hole in the Left Foam Grip
	(62) by sliding the Left Frame Guide (68) up or down.
	Make sure that the Lock Pin can be inserted fully into the
	hole. Hold the Left Frame Guide in place as you tighten
	two 1/2” Screws (10) into the Latch Insert and the Left
	Frame Guide. Note: It may be necessary to pull the Lock
	Knob (67) to access and tighten the Screws.
4.	Put the treadmill in the storage position (see HOW TO	4
	FOLD THE TREADMILL FOR STORAGE on page 23).	26		51
		129
	Have a second person hold the treadmill in the upright posi-
	tion. Place the U-base (20) against the base of the Uprights
	(65) as shown. Make sure that the U-base is turned so the
	Bumpers (98) are on the bottom. Finger tighten two 2”
	Bolts (26) and Base Washers (129) into the base of the			26		51
	Uprights and the U-base. Attach the U-base with two 3” Bolts		23
	(23), Base Washers and U-base Nuts (51) as shown. Tip the		65
	treadmill forward if necessary. Tighten the two 2” Bolts.
				129
5.	Make sure that all parts are properly tightened before	98	20
	you use the treadmill. Place a mat beneath the tread-
			98
	mill to protect the floor. For your benefit, familiarize				23
	yourself with the information on pages 25 and 26.
If you purchase the optional chest pulse sensor (see page		1
22), follow the steps below to install the receiver and the
short jumper wire included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove the
	indicated 3/4” Screws (40) from the Console Back (117).
	Remove the Console Back.
			117
			40	40
2. Connect the Short Jumper Wire (A) to the wire on the		2
	Receiver (B). Connect the other end of the Short Jumper
	Wire to the PULSE jack on the back of the Console (80).
	Turn the Receiver (B) so the cylinder is on the side		80
	shown, and hold the Receiver against the back of the
			A		Cylinder
	Console (80). Attach the Receiver with the two Small
					B
	Screws (C) included with the receiver.
			C

Make sure that no wires are pinched. See step 1.

Reattach the Console Back (117) with the 3/4” Screws (40).

You may discard the other wires included with the receiver.

7