See the inset drawing. Tie the wire tie

3. Identify the right Upright (77), which is marked	3	76			Plate
with a sticker. Have a second person hold the	3	76			Plate	77
right Upright near Base (83). Orient the right						77		83
Upright so that the bend in the plate is in the po-			Wire					83
sition shown.			Wire
See the inset drawing. Tie the wire tie in the			Tie
right Upright (77) securely around the end of the
Upright Wire (76). Then, pull the other end of
the wire tie until the Upright Wire is routed com-
pletely through the right Upright.
	77	76
	Wire Tie
4. Attach the right Upright (77) to the Base (83)	4
with a 3/8" x 2 3/4" Patch Bolt (7), a 3/8" x 1"	4
Patch Bolt (8), and two 3/8" Star Washers (11);					77		76
do not fully tighten the Patch Bolts yet. Be					77		76	83
careful not to pinch the Upright Wire (76).								83	11
									11
								8	7
5. With the help of a second person, carefully tip	5
the treadmill onto its right side. Partially fold the	5				Plate
Frame (51) so the treadmill is more stable. Do					Plate
not fully fold the Frame until the treadmill is		11	83	77
completely assembled.		11	83	77
Orient the left Upright (77) so that the bend in
the plate is in the position shown.
Attach the left Upright (77) to the Base (83) with	7							7
a 3/8" x 2 3/4" Patch Bolt (7), a 3/8" x 1" Patch	7	8						7
Bolt (8), and two 3/8" Star Washers (11); do not		8
fully tighten the Patch Bolts yet.					88
Attach a Wheel (91) to the indicated Extension					88	91
Leg (88) with a 3/8" x 2 3/4" Patch Bolt (7) and a						91
3/8" Nut (12). Do not overtighten the Nut; the							12	51
Wheel must turn freely.							12	51
With the help of a second person, tip the tread-
mill so that the Base (83) is flat on the floor.	8
	8

See the inset drawing. Tie the wire tie in the

completely assembled.

fully tighten the Patch Bolts yet.

3/8" Nut (12). Do not overtighten the Nut; the