Assembly

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included allen wrenches, assembly requires a phillips screwdriver			, two adjustable
wrenches	, a rubber mallet	, and pliers	.

As you assemble the elliptical exerciser, use the drawings below to identify the small parts used for assembly. The number in parenthesis below each drawing is the key number of the part, from the PART LIST on pages 24 and 25. The number following the key number is the quantity used for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled.

M6 Washer	M8 Split		M8 Washer	M10 Split	M8 Jam Nut	M10 Nylon
(102)–2	Washer (122)–4		(132)–4	Washer (118)–3	(91)–6	Locknut (90)–2
M4 x 25mm Round		M6 x 16mm Button		M8 x 52mm Button		M10 x 25mm Button
Head Screw (115)–2		Screw (103)–4		Bolt (100)–4		Screw (123)–3
M4 x 16mm Round		M4 x 16mm		Bolt Set (101)–2
M4 x 16mm Round		M4 x 16mm
Head Screw (125)–1		Screw (99)–4
		M10 x 92mm Carriage Bolt (124)–2
					M8 x 42mm Button
					Bolt (116)–4
		M10 x 105mm Button Screw (89)–2			M8 x 35mm Button
					M8 x 35mm Button
						Bolt (117)–2

1.Identify the Front Stabilizer (29), which has Wheels (44) attached to the front. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 92mm Carriage Bolts (124) and two M10 Nylon Locknuts (90).

124