8.Apply a small amount of the included Teflon® lubricant to a paper towel. Rub a thin film of the lubricant onto each Chrome Tube (45).
Identify the Left Upper Body Arm (9), which is marked with an “L.” Slide the Left Upper Body Arm onto the left Chrome Tube (45). Slide the Right Upper Body Arm (10) onto the right Chrome Tube (not shown). Make sure that the Upper Body Arms are on the correct sides. Next, slide an Upper Body Cover (15) onto the post on each Upper Body Arm.
Apply grease to the Pivot Axle (16). Insert the Pivot Axle into the Upright (2), the right Upper Body Cover (15), and the Right Upper Body Arm (10). Next, push the Pivot Axle into the Upright until the left end of the
Pivot Axle is flush with the left side of the Upright. Then, raise the Left Upper Body Arm (9), and insert the Pivot Axle into the left Upper Body Cover and the Left Upper Body Arm. Center the Pivot Axle and rotate it so the indicated hole is in the position shown.
9.Have another person hold the Left Handlebar (7) near the Upright (2) as shown. Connect the left Pulse Sensor Wire (11) to the Pulse Extension Wire (17). Slide a Handlebar Cap (12) onto the lower end of the Left Handlebar.
Slide the upper end of the Left Handlebar (7) into the tube on the front of the Upright (2), while sliding the lower end of the Left Handlebar onto the Pivot Axle (16). Attach the upper end of the Left Handlebar with two M8 x 42mm Button Bolts (116) and two M8 Jam Nuts (91); be careful not to damage the Wires (11, 17) as you insert the Button Bolts. Make sure that the Jam Nuts are resting in the hexagonal holes in the tube on the front of the Upright. Attach the lower end of the Left Handlebar with an M8 x 35mm Button Bolt (117) and an M8 Jam Nut (91). Press the tabs on the Handlebar Cap (12) into the left Upper Body Cover (15).
Attach the Right Handlebar (8) to the Upright (2) in the same way.
Hold the halves of the Upper Handlebar Cover (5) around the tube on the front of the Upright (2). Attach the Upper Handlebar Cover with an M4 x 16mm Round Head Screw (125); be careful not to damage the
Wires (11, 17).
8 |
|
|
|
| Grease |
| |
| Post |
| 15 |
| Hole |
| |
|
| 16 | 10 |
|
|
| |
|
| 15 |
|
| 9 |
| 2 |
|
|
| |
|
| 45 |
|
| Lubricate |
| |
9 |
|
|
|
5 |
| 2 |
|
|
| 8 | |
|
|
| |
| 116 |
|
|
125 |
|
|
|
| 11 | 17 | 15 |
|
| ||
|
| 91 |
|
7 | 12 | 16 |
|
|
| ||
|
|
| |
117 |
|
|
|
|
| Tab |
|
| 91 |
| |
8