Frame Assembly
1.
Before beginning assembly, make sure you have read and understood the information on page 5. This brief introduction will save you much more time than it takes to read it!
Open the parts bag labeled ÒFRAME ASSEMBLY.Ó
Press a 2Ó Square Inner Cap (33) and a 2Ó x 3Ó Inner Cap (24) into the Main Upright (3) in the indicated locations.
Press a 2Ó x 3Ó Inner Cap (24) into each end of the Stabilizer (5).
Attach the Stabilizer (5) to the Main Upright (3) with two 3/8Ó x 3 3/4Ó Carriage Bolts (52) and two 3/8Ó Nylon Locknuts (50). Do not tighten the Nylon
Locknuts yet.
2.Press 2Ó Square Inner Caps (33) into the Leg Lever (29) and the front leg on the Base (8) as shown.
Align the bracket on the Base (8) with the three holes in the Main Upright (3). Attach the Base with a 3/8Ó x 4Ó Bolt (65), a 3/8Ó Flat Washer (55), and a 3/8Ó Nylon Locknut (50). The Bolt must be inserted from the side shown. Do not tighten the Nylon Locknut yet.
Next, insert two 5/16Ó x 3Ó Bolts (78) into the Base (8) and the Main Upright (3) and finger tighten a 5/16Ó Nylon Locknut (21) onto each Bolt. Do not tighten the Nylon Locknuts yet.
1 |
24 |
Support Tube |
33 |
3 |
50 |
24 |
5 |
24 |
52 |
2 |
33 |
3 Bracket
78
6529
50 55
21 8
Front Leg
3.Attach the Leg Lever Lock (11) to the front leg with a 5/16Ó x 3Ó Bolt (78), three 5/16Ó Flat Washers (80) and a 5/16Ó Nylon Locknut (21). Do not overtighten the
Nylon Locknut; the Leg Lever Lock must pivot easily.
Attach the Foot Plate (4) to the Base (8) with a 3/8Ó x 5 1/2Ó Bolt (57) and a 3/8Ó Nylon Jamnut (63).
3 | 80 |
|
Front |
| 78 |
Leg |
|
|
| 11 | 57 |
80 21
8
634
6