Maintenance and Troubleshooting

Incline

Ramp

Inspect and properly tighten all parts of the elliptical exerciser regularly. Replace any worn parts immedi- ately.

For smooth operation of the

elliptical exer- ciser, inspect and clean the incline ramp regularly using

a soft cloth and mild detergent. Other parts of the elliptical exerciser can

also be cleaned in this way. Keep liquids off the console. Never use abrasives or solvents.

PULSE SENSOR TROUBLESHOOTING

If the handgrip pulse sensor does not function proper- ly, see step 6 on page 13.

HOW TO CALIBRATE THE INCLINE SYSTEM

If the elliptical exerciser’s incline system is not working properly, activate the calibration process by following the steps below.

1.	Hold down the + button and the Program Select
	button at the same time for about five seconds.
	Note: Numbers may appear in the left and right
	displays. Disregard these numbers.
2.	Press the Program Select button again. Note: A

HOW TO MOVE THE ELLIPTICAL EXERCISER

Stand in front of the elliptical exerciser, hold the han- dlebars firmly, and place one foot against the ramp in the location shown below. Pull the handlebars until the elliptical exerciser can be moved on the front wheels, and carefully move the elliptical exerciser to the desired location. Then, place one foot against the ramp, and lower the elliptical exerciser. Due to the size and weight of the elliptical exerciser, use extreme caution while moving and lowering it.

Handlebars

Place your

foot here

Wheel

HOW TO LEVEL THE ELLIPTICAL EXERCISER

	combination of letters and numbers may appear in
	the displays.
3.	Press the 30° Ramp button. The ramp will move all
	of the way up and then all of the way down.
4.	Press the Program Select button three times. The
	console will then be in the normal operating mode
	and the elliptical exerciser will be ready for use.

If the elliptical exerciser rocks during use, turn one or both of the leveling feet under the rear stabilizer until the rocking motion is elimi- nated.

Leveling

Foot