2.Have another person hold the Upright (2) in the posi- tion shown. Make sure that the Upright is turned as
shown in drawing 3 below, and that the Upper Wire Harness (30) is on the right side of the indicated metal plate.
Connect the Upper Wire Harness (30) to the Lower |
| ||
Wire Harness (42). | Carefully pull the upper end of |
| |
the Upper Wire Harness to remove the slack from |
| ||
the Wire Harnesses. |
| Insert the Upright (2) into the | |
Frame (1). Be careful to avoid disconnecting or |
| ||
pinching the Wire Harnesses. | Attach the Upright with | ||
two M10 x 108mm Button Screws (70), two M10 Split |
| ||
Washers (73), and two 7.6mm Spacers (47). | Make | ||
sure that the curved sides of the Spacers are fac- |
| ||
ing the Upright. Be careful to avoid damaging the |
| ||
Wire Harnesses with the Button Screws. Do not |
| ||
tighten the Button Screws yet. |
|
| |
3.Slide a Weld Spacer (28) onto the axle on the left side of the Upright (2), with the open side of the Weld Spacer facing the Upright. Apply a small amount of grease to the axle.
Slide an Upper Body Arm (29) onto the axle on the left side of the Upright (2). Using the included Push Nut
Tool (96), tap a Push Nut (31) onto the axle; make sure that the Push Nut is turned as shown in the
inset drawing.
Attach the other Upper Body Arm (29) to the right side of the Upright (2) in the same way.
4.Look inside one of the Handlebar Covers (26) and locate the square tabs connecting the two halves. Gently lift the tabs and disconnect the halves.
Hold the two halves of the Handlebar Cover (26) around the tube on the left side of the Upright (2). Align the halves and press them together until they lock.
Attach the other Handlebar Cover (26) to the right side of the Upright (2) in the same way.
5
2 |
|
|
| 2 |
|
| Plate |
|
| 73 | 30 |
| 47 | |
| 70 | |
|
| 42 |
| 73 | 1 |
|
| |
| 47 |
|
3 |
|
|
|
| 2 |
| 29 | Grease |
| 28 | |
|
| |
| 31 | 29 |
| 96 | Axle |
31 | Axle |
|
|
| |
4 |
|
|
29 |
|
|
|
| 2 |
|
| 26 |
| 26 |
|
|
| 26 |