Assembly

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included allen wrenches, assembly requires a phillips screwdriver			, two adjustable
wrenches	, a rubber mallet	, and pliers	.

As you assemble the elliptical exerciser, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing is the key number of the part, from the PART LIST on pages 24 and 25. The second number is the quantity used in assembly. Note: Some small parts may have been pre- assembled. If a part is not in the parts bag, check to see if it is pre-assembled.

			7.6mm Spacer	M8 Jam Nut	M4 x 12mm	M4 x 16mm
M6 Washer	M8 Split	M10 Split	7.6mm Spacer	M8 Jam Nut	Round Head	M4 x 16mm
(64)–2	Washer	Washer	(109)–2	(86)–9	Screw (96)–1	Screw (98)–2
	(30)–4	(73)–2
M4 x 16mm	M6 x 16mm Patch
Round Head	M6 x 16mm Patch		M8 x 41mm Button	M8 x 56mm Button Screw (83)–4
Screw (69)–4	Screw (76)–4		Bolt (85)–4
M8 x 44mm Button Screw (84)–8				M8 x 79mm Bolt Set (65)–2
M8 x 38mm Button Bolt			M10 x 108mm Button Screw (70)–2
(105)–2

1.Identify the Front Stabilizer (8). While another person lifts the front of the Frame (1) and holds the Pedal Legs (4, 5) in the position shown, attach the Front Stabilizer to the Frame with four M8 x 44mm Button Screws (84) and a Support Plate (104).

While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (not shown) to the Frame in the same way.

1
1	4, 5
	4, 5
	8
104	84
104
84