NordicTrack NTCCEX04901 Console 3. Lift the top of the Console, To disconnect any wires, Pinched

Page 8

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR

If you purchase the optional chest pulse sensor (refer to

page 11), follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor.

1. Remove the four indicated screws from the back of the
Console (3). Lift the top of the Console.	Be careful not
to disconnect any wires.

2.Peel the paper off the adhesive pad on the back of the receiver (A). Orient the receiver as shown, and press it onto the Console (3) in the indicated location.

Connect the wire on the receiver (A) to the short jumper wire (B) as shown. Plug the other end of the short jumper wire into the indicated jack (C).

Refer to step 1 above. Reattach the top of the Console

(3) with the four screws.	Make sure that no wires are
pinched.

Note: Any other wires that are included with the chest pulse sensor may be discarded.

Screws

Image 8

Contents To operate this product, call Model No. NTCCEX04901 Serial NoSerial Number Decal Table of Contents Important PrecautionsBefore YOU Begin You use the recumbent cycleFront BackAssembly Console MakeMarked are facing the springs Page Seat Rail Slot Identify the Left Pedal 69 there is an L on Left PedalInto the Right Crank Arm not shown As possibleTo disconnect any wires Console 3. Lift the top of the ConsoleWith the four screws PinchedHOW to Adjust the Pedal Straps HOW to Adjust the Position of the SeatConsole when you pedal Features of the ConsoleHOW to USE the Manual Mode HOW to USE a Smart Program Select one of the four Smart programsProvides During your workoutsBattery Replacement Pulse Sensor TroubleshootingNext, locate the Reed Switch 61. Turn the Left For optimal performance of the pulse sensor, keepExercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyOty Description Key No Oty Seat Rail CoverR0303A Part No R0303A HOW to Order Replacement PartsLimited Warranty

If you purchase the optional chest pulse sensor (refer to

Console (3). Lift the top of the Console.

to disconnect any wires.

(3) with the four screws.

pinched.