ASSEMBLY
Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two
included allen wrenches, assembly requires a phillips screwdriver | , an adjustable | ||
wrench | , and a rubber mallet | . |
|
As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 18. The second number refers to the quantity used in assembly. Note: Some small parts may have been
M10 Nylon Locknut (26)Ð6 | M8 Split | M8 Washer (33)Ð2 |
|
Washer (58)Ð2 |
| ||
|
| Chrome Tube | Plastic Pedal |
|
| Washer (84)Ð2 | Spacer (85)Ð2 |
Front Stabilizer Bolt (86)Ð2 |
|
| |
|
| Pedal Screw (43)Ð6 | |
| Rear Stabilizer Bolt (60)Ð2 |
| |
|
| Incline Axle Screw (30)Ð2 |
1.Identify the Rear Stabilizer (59), which has Wheels (45) attached to it.
Attach the Rear Stabilizer (59) to the rear of the Frame
(1) with the two Rear Stabilizer Bolts (60) and two M10 Nylon Locknuts (26). Make sure that the Rear
Stabilizer is turned so the Wheels are not touching the floor.
2.Attach the Front Stabilizer (14) to the front of the Frame (1) with the two Front Stabilizer Bolts (86) and two M10 Nylon Locknuts (26).
1 |
| |
26 | 59 | |
26 | 45 | |
1 | ||
| ||
| 60 | |
2 |
| |
14 |
| |
86 | 26 | |
| ||
| 1 | |
26 |
|
5