NordicTrack NTEL08990 manual Removed previously. Be careful to avoid pinching the wires

3.Slide an M8 Split Washer (58) and an M8 Washer (33) onto an Incline Axle Screw (30). Tighten the Incline Axle Screw into one end of the Incline Axle (29). Next, apply a small amount of the included grease to the Incline Axle.

Align the indicated tubes on the Incline Frame (5) with the tubes on the Base (1). Make sure that the Incline

Frame is turned so the V-shaped grooves are on top. Insert the Incline Axle (29) through the Incline Frame and the Base. Note: It may be helpful to tap the Incline Axle with a rubber mallet to insert it.

Slide an M8 Split Washer (58) and an M8 Washer (33) onto the other Incline Axle Screw (30). Tighten the Incline Axle Screw into the open end of the Incline Axle

4.Remove the four Console Screws (35) and the four Console Washers (44) from the Console (87).

Connect the console wire to the Harness Extension

Attach the Console (87) to the Upright (2) with the four Console Screws (35) and the four Console Washers

(44)removed previously. Be careful to avoid pinching the wires.

5.Remove the four M10 Nylon Locknuts (not shown) from the welded bolts on the front of the Frame (1).

Lay a cloth over the front of the Frame (1) to protect it from scratches. Lay the Upright (2) in the position shown. Connect the Harness Extension (51) to the Wire Harness (25).

6

3
	V-shaped Groove
	5
	58
	33
	30
Grease	29
	Tubes
33
58
30	1
	Tubes
4	87
Console
Wire
51
44	2
35	35
5	2
	51
	25
Welded Bolts
	1