NordicTrack NTEL08990 manual Left Pedal is turned as shown. Attach the Left

6. Align the two holes in the front of the Upright (2) with	6
the two welded bolts on the front of the Frame (1).
	2
Next, pivot the Upright (2) about halfway to a vertical		26
position. Refer to the inset drawing. As you raise
the Upright, look into the lower end and make sure
that the Harness Extension (51) and the Wire
Harness (25) do not get pinched between the
Upright (2) and the Frame (1). In addition, feed the
slack in the Harness Extension and the Wire	5	1
Harness into the Upright. Continue to raise the
Upright until the four welded bolts are inserted through	Welded Bolts
the bracket at the bottom of the Upright.
Lift the front of the Incline Frame (5). Tighten an M10	2
Nylon Locknut (26) onto each welded bolt.	51
	25
	1
7. Identify the Left Pedal Arm (3), which has an ÒLÓ sticker	7
on it. Next, identify the Left Pedal (41), which has the
	43
letter ÒLÓ molded onto the bottom.
Turn over the Left Pedal Arm (3) as shown. Insert the		Welded
three plastic posts on the Left Pedal (41) into the three		Bolt
indicated holes in the Left Pedal Arm. Make sure that	3
the Left Pedal is turned as shown. Attach the Left
Pedal with three Pedal Screws (43).
Attach the Right Pedal (not shown) to the Right Pedal		Open Side
Arm (not shown) in the same way.		Plastic Posts
	41
8. Apply a small amount of grease to the axle on the left	8
Crank Arm (6).
Side a Plastic Pedal Spacer (85) and the Left Pedal
Arm (3) onto the axle on the left Crank Arm (6). Note: It
may be helpful to use a rubber mallet to tap these parts
on. Be careful not to confuse the Left Pedal Arm		Grease
with the Right Pedal Arm (not shown); look at the
	3
position of the round tube to identify the Left Pedal		6
Arm. Next, tap a 3/4Ó Axle Cap (61) onto the axle.		85
Attach the Right Pedal Arm (not shown) in the same way.
	61	Round
		Tube

7