NordicTrack NTEL08990 manual HOW to USE the Elliptical Crosstrainer, Incline Adjustment

Page 9

HOW TO USE THE ELLIPTICAL CROSSTRAINER

INCLINE ADJUSTMENT

As you exercise on the elliptical crosstrainer, you can vary the effect of the exercise by raising or lowering the incline frame. First, position the pedal arms side by side as shown. Next, lift the incline frame slightly and pull the incline knob. Raise or lower the incline frame to the desired position and release the incline knob. Move the incline frame up or down slightly until the pin on the incline knob snaps into one of the four holes in the incline bracket. Push the incline knob to make sure that the pin is fully inserted into the hole.

Incline

Bracket

Incline

Frame

Incline

Knob

HOW TO PLUG IN THE POWER SUPPLY

Make sure that the power supply is plugged into the elliptical crosstrainer (see step 11 on page 8). Next, plug the power supply into an electrical outlet.

Note: Each time the power supply is plugged in, the ellip- tical crosstrainer will automatically calibrate itself. Calibration will take

EXERCISING ON THE ELLIPTICAL CROSSTRAINER

To mount the elliptical crosstrainer, hold the handlebar and step onto the pedal that is in the lowest position. Next, step onto the other pedal. Push the pedals until they begin to move with a continuous motion. Note:

The pedal disks can turn in either direction. It is recommended that you move the pedal disks in the direction shown by the arrow below; however, to give variety to your exercise, you may turn the pedal disks in the opposite direction.

Handlebar

Pedal Disk

Pedal

To dismount the elliptical crosstrainer, wait until the pedals come to a complete stop. Note: The elliptical crosstrainer does not have a freewheel; the ped- als will continue to move until the flywheel stops. When the pedals are stationary, step off the highest pedal first. Then, step off the lowest pedal.

HOW TO USE THE UPPER BODY ARMS

less than one minute. During cali-

bration, the letters ÒCALÓ will appear in the left LED display and the indicators in the TRAINING ZONE display will light in a rapid sequence.

The upper body arms are designed to add upper-body exer- cise to your work- outs. Move the upper-body arms forward and back as you exercise in order to work your arms, back, and shoulders.

Upper Body Arms

Handlebar

To exercise only your lower body, hold the handlebar as you exercise.

9

Image 9
Contents QUESTIONS? Model No. NTEL08990 Serial NoCustomer HOT Line Table of Contents Important Precautions Front Before YOU BeginBack Right SideWrench A rubber mallet AssemblyRemoved previously. Be careful to avoid pinching the wires On. Be careful not to confuse the Left Pedal Arm Left Pedal is turned as shown. Attach the LeftChrome Tube is turned exactly as shown Center the Arm AxleMay look different from the one pictured Incline Adjustment HOW to USE the Elliptical CrosstrainerHOW to Plug in the Power Supply HOW to USE the Upper Body ArmsDescription of the Console HOW to USE the Manual ModePower When you are finished exercising, turn off16 to turn off the demo mode Training zone displayÑAs youSelect one of the five preset programs HOW to USE a Preset ProgramWhenpower.the program is finished, turn off Exercising Press any button onHOW to Connect Your Portable Stereo HOW to Connect Your Home Stereo HOW to Connect Your Computer Press the play button on your CD player to Start the program Maintenance Information MODE/DEMO ModeImportant Make sure that there is not Exercise Intensity Conditioning GuidelinesFat Burning Aerobic ExerciseQty Description Part LISTÑModel No. NTEL08990R0100A 2667 Limited Warranty HOW to Order Replacement Parts